Torque Values for Installation of Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System

Question

Question:

I noticed that a couple of the jack bolts are loose and was wondering how much torque is needed when tightening them

asked by: Keith V

0

Expert Reply:

Please note the linked Installation Instructions for the Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System, # LC675817 that identify manufacturer's stated torque values for hardware. I have also included an installation video as well.

We have a very cost effective 0 - 150 ft. lbs.1/2" Drive Torque Wrench, # PTW3001C if needed.

expert reply by: Michael R

0

Answer 1

I attached a link to the install instructions for the Lippert Ground Control 3.0 part #LC675817 which is the kit the leg part #LC305339 is a part of. On page 6 of the instructions is the torque spec for mounting the jacks. Spoiler…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Answer 4

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 5

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 6

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 7

Hey Frankie, The bracket for the Timbren Suspension Enhancement System #TFR250SDJ has a locknut in it that makes it feel like the bolt (part #4) is fully tightened when it's not. Their techs have stated that you just have to push past this point…

view full answer...

Torque Values for Installation of Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching