Replacement Sliding Battery Tray To Hold Two 6 Volt Batteries On a 1997 Tioga RV Motorhome

Question

Question:

My 97 Tioga RV has a sliding battery tray that is 14.5” L x 11.25” W x 2” H. It hold two T-105 6V batteries in series. Do you make one close to those dimensions?

asked by: Mark

0

Expert Reply:

The Kwikee RV Battery Tray - 14-9/16" Long x 15-1/2" Wide # LC366485 and Kwikee RV Battery Tray - 13" Long x 16-1/8" Wide # LC366357 are the closest we have to the battery tray you have on your 1997 Tioga RV.

expert reply by: Bud M

0

Answer 1

The dimensions of a Group 27 battery are 12 inches long by 6-5/8 inches wide by 9-3/16 inches tall so for a box that can carry two of them we have the TorkLift PowerArmor Locking Battery Box #TLA7708R which has dimensions of 26-3/4" long x…

view full answer...

Answer 2

The vent ports of the Commercial Grade Battery Box #329-HM426 are around the top of the box underneath the lid. See attached picture to see the cut outs along the top of the box.

view full answer...

Answer 3

The closest sliding battery tray we have available to the dimensions you listed is the Kwikee RV Battery Tray #LC366330, which measures 7-1/2 inches wide, 12-1/8 inches deep, and 2-1/2 inches tall. The next closest size up we have is the Kwikee…

view full answer...

Answer 4

To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…

view full answer...

Answer 5

I have a solution for you, but you will need to know your battery size and determine how much space you've got in your battery compartment to help decide which Kwikee battery tray is going to work the best for you. The #LC366328 is 16-7/8"…

view full answer...

Answer 6

I have attached for you below the dimensions of the Kwikee Heavy Duty Tray Assembly Kit part #LC370793. The tray will slide out 11" while fully extended. Please note you will also need theTrim Kit for Kwikee Heavy Duty Tray Assembly Kit part…

view full answer...

Answer 7

The RV Switch #37213095 doesn't have an option to add a faceplate, but we have an alternative with part #37212625 which comes with a small faceplate with it and carries the same on/on function that you're looking for.

view full answer...

Answer 8

I added a diagram of the part dimensions for the Kwikee RV Battery Tray #LC366329 below. The instruction manual doesn't give any dimensions beyond the overall measurements, but you can reference the drawing to see if it will fit for your…

view full answer...

Answer 9

The Elixir ELX-20 is a bit of an oddball converter design so there isn't an exact replacement but the Progressive Dynamics RV Power Control Center with AC/DC Panel and Converter/Smart Charger - 35 Amp #PD4135K would be the closest option to it.…

view full answer...

Replacement Sliding Battery Tray To Hold Two 6 Volt Batteries On a 1997 Tioga RV Motorhome

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching