Best Grass Catcher for Toro Lawn Mower

Question

Question:

Smaller toro timecutter. would like to add aluminum basket. Rackem grass catcher+fo toro timecutter 75734`?

asked by: Darrell L

0

Expert Reply:

Your Toro Timecutter should have the Z-Cut deck. I have attached a picture below so you can confirm. You will want the Rack'Em Grass Catcher for Toro Lawn Mower with Z-Cut Deck item # RCMMS4-EXS1-TORO. The custom face plate provides the connection point needed to attach the catcher to your mower. The catcher design is light-weight and easy to handle.

If your Toro does not have the Z-Cut deck you will want the Rack'Em Grass Catcher for Toro, Bobcat, and Exmark Lawn Mower item # RCMMS4-EXS1.

expert reply by: Jerred H

0

Z-Cut Toro Deck
(click to enlarge)

Answer 1

Since your Toro Timecutter does not have the Z cut deck the Grass Catcher you'd need is the part #RCMMS4-EXS1.

view full answer...

Answer 2

If your Toro Timecutter has the Z cut deck that extends out further than the rear wheel, you'd use the Rack 'Em #RCMMS4-EXS1-TORO catcher. If you have the regular deck, you'd use #RCMMS4-EXS1.

view full answer...

Answer 3

The correct catcher will depend on the discharge opening behind that deflector shown in your photo. If it has the deck with a Z-bracket as shown in the provided photo, you'd use #RCMMS4-EXS1-TORO. If it doesn't have the z-slot, but has a 4…

view full answer...

Answer 4

I checked with Rack Em and the Grass Catcher they recommended is the part #RCMMS4-EXS1-TORO for your 2013 Toro MX4260 model 74640.

view full answer...

Answer 5

If your Toro Timecutter has the Z cut deck that extends out further than the rear wheel, you'd use the Rack 'Em #RCMMS4-EXS1-TORO catcher. If you have the regular deck, you'd use #RCMMS4-EXS1. The Z deck has notches or slots in it as…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

Hey Tony, the correct Rack Em Grass Cather for your Toro Grandstand 52 is the part #RCMMS4-EXS1-TORO.

view full answer...

Answer 11

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 12

Factory brake controllers seem to unfortunately be very temperamental and usually quite a bit more expensive that an aftermarket brake controller so I have to recommend going with an aftermarket option. Luckily there is a brake controller port so…

view full answer...

Best Grass Catcher for Toro Lawn Mower

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching