How Much Does the MORryde RV Generator Slide Out Tray Weigh?

Question

Question:

What is the weight of item Part #MR79RR?

asked by: Thomas E

0

Expert Reply:

The MORryde RV Generator Slide Out Tray - 25-3/4" x 26-1/4" - 100 Percent Extension - 300 lbs item # MR79RR weighs 52 lbs.

expert reply by: Jerred H

0

Answer 1

The MORryde Generator Tray, #MR79RR is 25-3/4" x 26-1/4", has an approximate 24" extension. While the overall dimensions are 25-3/4" in length, the tray itself is 24" with a 24" extension. This is considered a 100%…

view full answer...

Answer 2

For the MORryde #MR79RR slide out generator tray, there is not a lock or latch for the full out position. If it were me, I would look for a place to place a wedge to keep it out as necessary. I can't see any reason that you cannot run a generator…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 7

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

Hello Steve. I do have a good solution for you, but I cannot recommend using the Malone Adapter #MPG544. Since it is rated for towing only 4,000 lbs, your 8,000 lb towed vehicle would be double the max towing capacity. You are right about there being…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

How Much Does the MORryde RV Generator Slide Out Tray Weigh?

Product Page this Question was Asked From

Continue Researching