What Style Fender With Step Fits Sea Doo Trailer

Question

Question:

I want galvanized fenders for my Sea Doo trailer WITH FRONT AND BACK STEPS, but can’t find anyone selling them. Steps are available in plastic, but not galvanized. Do you sell any with steps?

asked by: Jan C

0

Expert Reply:

The closest fender that I can find on our site that is compatible with your Sea Doo trailer is Fulton Single Axle # HP49VR.

Below is a link to a review of the fender.

expert reply by: Noah E

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

The closest radial tire size I would have to replace the 4.80-12 bias tire size is the Kenda Karrier S-Trail ST145R12 Radial Trailer Tire #AM10130. The 4.80-12 bias tire is 20.7 inches tall and 4.9 inches wide. The 145R12 radial tire is 21.3 inches…

view full answer...

Answer 4

It may be possible to upgrade the 4.80-12 tires on your Karavan trailer. The main factor we need to consider is the clearance between the tire and the fender, as well as the clearance between the inside of the tire and the trailer frame. Our rule of…

view full answer...

Answer 5

You do not need to get your trailer tires balanced before mounting. Some people like doing so but it isn't something required as trailer tires don't figure into handling the way car tires do. If you want you can add balancing beads after the…

view full answer...

Answer 6

The torque spec depends on the lug nut type, wheel size, and material. For the Kenda Karrier S-Trail ST145/R12 Radial Tire w/ 12" Galvanized Spoke Wheel #AM31202 the torque spec would be 75-85 ft-lbs. I have attached a chart below for your…

view full answer...

Answer 7

A 4.80 x 12 trailer tire fits on a 12 inch x 4 inch wheel, so I would guess that is the size of your wheel. The size of the wheel is important when choosing replacement tires. The highest capacity tire that we carry for a 12 inch x 4 inch wheel is…

view full answer...

Answer 8

With an Enclosed Trailer Ramp Spring #ERS120D81 when the door is lowered it will pull the cables which will turn the pulleys and put tension on the springs. The cables could not be detached with the ramp door lowered because the springs would…

view full answer...

Answer 9

Based on your picture the Ventline cover part #BV0554-01 that you referenced is the correct replacement lid for your trailer. You listed a smaller measurement but you most likely measured the wrong area as it's very obvious from your picture that…

view full answer...

Answer 10

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...

Answer 11

Sounds like there could be a short in your trailer wiring for one of the brakes or there could have been a mechanical failure in that one brake assembly. The second possibility is more likely since only one brake was affected. First inspect the…

view full answer...

What Style Fender With Step Fits Sea Doo Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching