What All Do You Need To Use A Prewired Tire Linc System On A 2022 Micro Minnie Winnebago

Question

Question:

Hello .. my new camper 2022 Winnebago micro Minnie 2108 came prewired with a tire linc module .. is this the system I would purchase for that or is there something cheaper since it already has a module. Thanks

asked by: Haley S

0

Expert Reply:

Good question.

You will need the Tire Linc OneControl TPMS w/ Signal Booster for RVs and Trailers - Bluetooth - 4 Tire Sensors
# LC37VR.

There will be a repeater "dock" that you can just plug the repeater into and follow the instructions to complete the set up.

expert reply by: David B

0

Answer 1

If your 2003 Dodge Ram 1500 came with a factory 7-way or 4-way there will be a port under the dash to plug in Tekonsha adapter part #3020-P to install Tekonsha P3 part #90195. If your truck did not come with a factory connector at all, you will…

view full answer...

Answer 2

All you need is a ball mount that allows you to tow the trailer level. You can measure for the amount of rise needed to select the correct model. A ball mount with rise is needed when the trailer coupler is higher than the hitch receiver on the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

For an 8 inch high low adapter to use with your Blue Ox tow bar you would want the Roadmaster part #RM-048-8.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 11

The P3 brake controller, #90195, will go into a sort of sleep mode after it detects no movement for 15 minutes. While it is on it does not draw very much power. What you can do to make sure it goes to sleep is exit the truck after turning it off,…

view full answer...

Answer 12

Hey Donald, the best Blue Ox weight distribution would be the pat #BXW0550 as it has a perfect tongue weight range for your 450 lb tongue weight trailer.

view full answer...

What All Do You Need To Use A Prewired Tire Linc System On A 2022 Micro Minnie Winnebago

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching