Will Optronics A57WB 7-Way to 5-Pole Trailer Connector Adapter Work With a 4-Pole Trailer Connector
Question:
Will the flat end on this unit fit a 4 way flat3 male, 1 female for groundconnector, just carrying tail and stop light on a bump step?
asked by: Jerry W
1
Helpful Expert Reply:
The 5-pole end on the Optronics # A57WB 7-way to 5-pole trailer connector adapter will work with most trailer side 4-pole connector such as you describe. Some 4 pole connectors have a plastic shroud around the 3 exposed pins. You'd simply need to cut that away with a sharp utility knife, and it'll work just fine.
expert reply by:
Mike L
1
Product Page this Question was Asked From
Adapter 7 Pole to 5 Pole Flat Wired Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 7 Round - Blade
- Plug and Lead
- 5 Flat
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommended E-Z Lube Hub and Rotor Assembly for 6K Axles
- Article: Cargo Tie-Down Methods
- Q&A: Does Trailer Wheel Hub/Brake Drum Need to Be Replaced if Inside Surface is Grooved
- Q&A: Boat Guide On For a Karavan Boat Trailer With 2" X 5-1/2" Frame Rails
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Replacement 5-Way Connector for Ranger Boat Trailer
- Q&A: Replacement Hub/Rotor and Bearings for Tie Down Engineering TDE46245
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class