What Type Of Fuse Does The MaxxAir MaxxFan Dome Use?

Question

Question:

Can you please advise replacement fuse for MaxxAir MaxxFan Dome Plus that is in my 2021 Casita trailer. I think it is a 4 amp slow fuse.

asked by: Bob B

0

Expert Reply:

The correct replacement fuse for your MaxxFan Dome Plus Roof Vent w/ 12v Fan # MA00-03810B is a 5 amp GMA fast acting fuse.

expert reply by: Bryce D

0

Answer 1

When it comes to replacing the motor on your Kwikee steps I recommend The Motor Upgrade Kit for Kwikee Electric RV Steps #LC379145, This motor will fit step series 22, 23, 28A, 30, 32, 33, 34, 35, 36, 38, and 40 and your 903206001 is a 32 series.…

view full answer...

Answer 2

If the Kwikee 32 Series steps that you have were built in 2003 and you haven't done any work to them then the replacement motor that you are looking for is the part #LC379608. This is for 32 Series steps that were manufactured between 2000…

view full answer...

Answer 3

The overall dimensions I'm seeing for the Dometic RM7732 show it being 59-5/8" tall x 33-9/16" wide x 25-15/16" deep. While we won't have a prefect fit we do have the Everchill RV Refrigerator w/ Freezer…

view full answer...

Answer 4

The Replacement Keypad #MA48GR is the correct part for your MaxxFan Deluxe Roof Vent #MA00-05100K.

view full answer...

Answer 5

The power draw of the MaxxFan Dome Plus Roof Vent part #MA00-03810B per the manufacturer is 2 amps. This is the max power draw with the fan and light run concurrently at the highest setting.

view full answer...

Answer 6

The MaxxFan Dome Plus Roof Vent w/ 12V Fan #MA00-03810B only draws 2 amps.

view full answer...

Answer 7

The MaxxFan Deluxe Roof Vent w/ 12V Fan #MA00-06401K only draws 5 amps so you don't need to go crazy with the wiring gauge but I would still recommend 10 gauge like part #10-1-1 (sold by foot) as it's heavier than you'd ever need and will…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 12

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

What Type Of Fuse Does The MaxxAir MaxxFan Dome Use?

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching