How Do the Replacement Keys for Bauer Locks Come Cut

Question

Question:

If I Order a replacement key for a bauer door lock. Is it a blank key and will it be cut if I give the key number.

asked by: Jesse

0

Expert Reply:

We do not cut any of the keys. The keys that we carry are provided by the manufacturers for their products. So a key like the Replacement Key for Bauer RV Lock # BA64ZR would replace a key for a Bauer 307 lock core. If you wanted to provide me with the key number you are needing, I would be happy to help you find the correct replacement key(s) that you need.

expert reply by: Scott S

0

Answer 1

The Global Link RV Entry Door Locking Latch Kit part #295-000019 is a universal entry door latch designed for a 2-1/2" wide x 3-1/2" tall to 3" wide x 4" tall cutout with a door thickness of 1-1/4" to 1-1/2". This covers…

view full answer...

Answer 2

We may have some potential options for replacing the tack room door lock on your Featherlight trailer. Is the 5" L x 5" H dimension you gave for the door cutout or the lock itself? The best way to find the right replacement lock is to go by…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

I contacted Trimark in regards to a replacement part for the Trimark 030-0900. 030-0900 is actually a series number not a specific part number. To find the part number you will need to take the interior handle completely off the unit. On the back…

view full answer...

Answer 5

For the weight capacity, you do not technically need a weight distribution system. However, due to the design of the trailer, I do recommend using a weight distribution system for the sway control features as the crosswinds or passing vehicles may…

view full answer...

Answer 6

The manual for the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters - White #AT91230 lists the wire as orange but the manual for Atwood water heaters like AT94022 list the wire as red. It's referring to the wires…

view full answer...

Answer 7

If you are wanting to install side marker lights on your motorcycle trailer that blink with the turn signal, it will need to be tapped into the turn signal/brake light wire for that side. However, just doing this will also allow the side light to…

view full answer...

Answer 8

In the attached diagram the A measurement is actually the distance from the center of the spring hangers for a single axle trailer. The spring eye to spring eye measurement for your leaf springs will be slightly different. The B measurement that you…

view full answer...

Answer 9

If your Tekonsha P3 Brake Controller, part #90195, displays the error message OUTPUT SHORTED NO BRAKES, the potential causes are a short in the brake output circuit somewhere between the brake controller and the trailer brake assemblies, or a shorted…

view full answer...

Answer 10

I recommend starting with the Roadmaster Rear Anti-Sway Bar, #RM-1139-147. This will reduce side-to-side movement for a noticeable improvement in your vehicle's stability and reduced body roll. For the front, I recommend the Timbren Front…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

How Do the Replacement Keys for Bauer Locks Come Cut

Product Page this Question was Asked From

Continue Researching