Replacement Tubing And Couplers Joints For RV Hot Water Line

Question

Question:

This line is pretty much what Im looking for. My RV has a combination of blue and white hose - some like this braided hose and some PEX. I want to replace the PEX with braided hose, replace all the plastic Ts, and use worm drive clamps. This hose is only rated for cold water. Do you have a similar hose that is rated for hot water?

asked by: Kirk D

0

Expert Reply:

We have the Valterra PVC Tubing for RV Fresh Water Systems - 100' Long - 1/2" ID x 5/8" OD - 135 F # W01-1600. It can withstand temps up to 130 degrees.

If you need new T's I suggest the Valterra T-Connector - 1/2" Barb x 1/2" Barb x 1/2" Barb - Polypropelene # RF843.

You can find elbow joints here, Valterra 90-Degree Elbow - 1/2" Barb x 1/2" Barb - Polypropelene # RF844.

And here are some couplers. Valterra Coupler - 1/2" Barb x 1/2" Barb - Polypropelene # RF845.

expert reply by: David B

0

Answer 1

Yes the 5/8 inch pex clamps would be the correct size to use with Valterra Braided PVC Tubing #W01-1800.

view full answer...

Answer 2

While we don't carry Sharkbite, the inner diameter of the Valterra Braided PVC Tubing for RV Fresh Water #W01-1800 is 1/2 inch and designed for 1/2 inch fittings like #RF845.

view full answer...

Answer 3

For the Valterra Braided PVC Tubing for RV Fresh Water - 50' Long - 1/2" ID x 5/8" OD - 73 F #W01-1800, the manufacturer offers the following: Valterra Male Adapter - 3/8" MPT x 1/2" Barb - Polypropelene #RF840 Valterra…

view full answer...

Answer 4

The Phoenix Faucets 4" Dual Handle RV Tub/Shower Diverter Faucet w/ D-Spud #PF213321 has a flow rate of 2.5 gallons per minute which is also the same for the RV Shower Valve w/ Vacuum Breaker #277-000027. This is basically the standard RV flow…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Replacement Tubing And Couplers Joints For RV Hot Water Line

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching