What Catalytic Converter Will Fit My 2006 Fleetwood Flair V10 With Ford F-53 Chassis

Question

Question:

Need catalytic converter for my 2006 fleetwood flair V10

asked by: Michael A

0

Expert Reply:

Your 2006 Fleetwood Flair V10 is built on a Ford F-53 chassis. The replacement part you need is the MagnaFlow Ceramic Catalytic Converter - Stainless Steel - Universal - California Approved, part # MF29RP. The representative I spoke with from MagnaFlow also recommended that you speak with a Referee to make sure this part meets the necessary requirements.

I have included a product description link below.

expert reply by: Mark Smith

0

Answer 1

When choosing the slider you want to measure the outside front of box width including the flange. Then you need to select a slider that extends a minimum of 2-1/2 inches beyond each side of the box width. For example, the Black Solera Slider…

view full answer...

Answer 2

When installing an awning like the Solera Smart Arm 12V Power RV Awning #LC517486, the arms will be secured to the wall framing. When the awning extends there will be quite a bit of leverage, so it is important to mount the awning to an area where…

view full answer...

Answer 3

Yes, the MagnaFlow Stainless Steel Catalytic Converter - Direct-Fit #MF55323 is for a 3 inch pipe set up. It is a direct fit for the following: 2000 - 2001 Ford Excursion 5.4L V8 and 6.8L V10 Engine 2002 - 2004 Ford Excursion 5.4L V8 Engine 2000 -…

view full answer...

Answer 4

For your 2018 Jeep Wrangler Unlimited JL there is the Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM49RR that you found that is for the larger 33-37" tires. It comes with the Custom Mounting Brackets #RM34RR and Roadmaster…

view full answer...

Answer 5

We do have an Exact Center steering stabilizer fit for your 2020 Jeep Wrangler JL (unless it is a Rubicon model with electronic sway bar disconnect), though it is different than the part number you mentioned. The right one will depend on the tire…

view full answer...

Answer 6

For your 2000 Fleetwood Flair, I recommend the 2000 Ford F-53 SumoSprings Rebel Custom Helper Springs - Front Axle #SSF-173-40-2. These springs will give you progressive load control and the springs work independently to compensate for off balance…

view full answer...

Answer 7

I would be happy to help! For your 1999 Nation Sea View Motorhome built on the Ford F-53 chassis with a 20500lb GVWR you will need the SumoSprings #SSR-187-54-1 with a 7000lb capacity for the rear axle, and the #SSF-172-40-2 with a 3000lb rating for…

view full answer...

Answer 8

You absolutely have the right SumoSprings for your 2003 Fleetwood Pace Arrow 37A on a Ford F-53 chassis. The part number you mentioned is for the front springs, but I do recommend adding the rear springs as well, or starting with the rear and then…

view full answer...

Answer 9

For the front axle of your 2003 Gulfstream Sun Voyager Motorhome on a 2002 Ford F-53 chassis, you'd want to use the #SSF-172-40-2 SumoSprings.

view full answer...

What Catalytic Converter Will Fit My 2006 Fleetwood Flair V10 With Ford F-53 Chassis

Product Page this Question was Asked From

Continue Researching