Availability of Replacement Safety Chain U-Bolts for B and W Gooseneck Hitch

Question

Question:

I have a bandw companion hitch and I am look for the 2 u bolts that secure to the main post that goes into the bed of the truck

asked by: Michael B

0

Expert Reply:

Sounds like you are looking for the replacement safety chain u-bolt kit for your Turnoverball part # BW1900-2-1600.

expert reply by: Jameson C

0

Answer 1

The inner measurement of the U-bolt is 1-5/8 inches. It is also 2 inches from center to center of the U-Bolt's threaded studs.

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 7

No, the Replacement Base for B&W Companion OEM 5th Wheel Trailer Hitch for Chevy/GMC #BWRVB3705 is not going to work with your 2024 GMC Sierra 2500. You're going to want the Replacement Base for B&W Companion OEM 5th Wheel Trailer Hitch…

view full answer...

Answer 8

Hey Edward, so B and W has a Companion hitch that fits directly to the OEM pucks of your 2023 GMC Sierra 3500 with the part #BWRVK3710 so what that means is you have two options. You could go with the #BWRVK3710 and sell your old hitch second hand to…

view full answer...

Answer 9

The B&W Companion OEM 5th Wheel Hitch w/ Slider for Chevy/GMC Towing Prep Package #BWRVK3775 you're looking at will work fine with your new Chevrolet Silverado. This hitch has 3 height adjustments so you'll be able to set the hitch height…

view full answer...

Answer 10

The model of B&W Companion 5th wheel hitch you have is the older one that used U-bolts. And while I'm sure it has aged gracefully for the most part, if you have U-bolts that need replacement the only option is to convert your hitch to the new…

view full answer...

Answer 11

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 12

The B&W Companion 5th Wheel Trailer Hitch #BWRVK3500 (RVK3500) is the complete 5th wheel hitch that will mount to an existing B&W Turnoverball Gooseneck Hitch socket in the truck bed. The part #BWRVB3500 (RVB3500) that you also referenced is…

view full answer...

Availability of Replacement Safety Chain U-Bolts for B and W Gooseneck Hitch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching