Is There a Day & Night Screen For 92 Inch LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen

Question

Question:

Is there a day and night screen, so if I wanted to have privacy at night? How wide is the top mount?

asked by: Keith F

0

Expert Reply:

There is not a day and night screen, simply the standard screen for the LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen - 92" Wide # 3441409200PBK.

The width is the entire assembly so the top mount of the # 3441409200PBK is 92 inches wide.

expert reply by: Kyle S

0

Answer 1

The LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screens do not use magnets to stay down. You simply need to pull the lanyard and you can actually stop it at any point of its length and it will automatically stop due to a mechanism in the…

view full answer...

Answer 2

I contacted the manufacturer asking if they had a diagram on how to adjust the tension. Please note the attached image showing where to use an Allen wrench to turn the adjuster on the LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen,…

view full answer...

Answer 3

I spoke with LaSalle Bristol and the side rails of the LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screens like the #3441409200PBK are 2-1/2 inches wide. So you'd lose a total of 5 inches in width.

view full answer...

Answer 4

Since your door opening is 95-7/8 inches wide the correct fitting LaSalle Bristol CrossBreeze Toy Hauler Screen is the part #3441409200PBK which has a screen width of 92 inches. The railing around the screen would easily fill up the extra space.

view full answer...

Answer 5

I spoke with the manufacturer and their tech confirmed that the LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen - 99-1/8" Wide Item #3441409912PBK actually come 1/8" smaller than what it's listed as so it will fit your 99"…

view full answer...

Answer 6

The LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen - 92" Wide Item #3441409200PBK just requires some self tapping screws like Screw - Self-Tapping Phillips Head - 8 x 3/4" Item #1131832.

view full answer...

Answer 7

The 7-way on your trailer could be wired correctly as-is. Not all 7-ways will have wires run to every one of the pins. Typically, if there are only 5 wires you will be missing the circuits will be the 12-volt accessory and the reverse light circuit.…

view full answer...

Answer 8

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 9

A drop axle certainly can make it tough to reach the star wheel adjuster on a drum brake. The adjuster spoon tool we offer #W80630 has a 90-degree bend that will often let you get access to the adjuster even on a drop axle. Essentially you will need…

view full answer...

Answer 10

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 11

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 12

For your 4x6 utility trailer, I recommend using the Taskmaster 4.80R12 Radial Trailer Tire part #TT48012C. This tire has a radial ply construction which will be better for the longer highway trips you intended to make. It has a load range C rating…

view full answer...

Is There a Day & Night Screen For 92 Inch LaSalle Bristol CrossBreeze Adjustable Toy Hauler Screen

Product Page this Question was Asked From

Continue Researching