bing tracking image
Q & A Icon

What SnapPad Will Fit My Lippert 6 Inch Square Stabilizer Feet  

Question:

Hi, will SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 6 Square Jack Feet - Qty 4 Item # SN99FR fit my travel trailer stabilizers. I have a 2017 Highland Ridge Open Range UT2804RK with Lippert stabilizers LCI model #369777 both in front and rear. The feet measure 5 7/8”. Also, I live in Minnesota and what would be the optimal temperature for installation. Thanks,

1

Helpful Expert Reply:

Yes, the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 6" Square Jack Feet - Qty 4 # SN99FR will work for you.

Install temp is not a huge issue, takes a few minutes per pad. The pads will maintain structural integrity down to -40 degrees and up to 120F degrees. It is suggested that install will be easier if temps are over 50 degrees.

SnapPad installation should be performed on a level or near level surface preferably a hard surface like concrete or asphalt. Wheel chocks should be placed in front of and behind the RV wheels for additional safety.

Spread a small bead of dish soap around the lip of the SnapPad and metal landing foot to aid installation. Do NOT use any petroleum based lubricant, like WD-40 as it may negatively react with the binder in your SnapPads.

Extend the foot until it is a few inches from the ground. Slide the SnapPad under it and align it.

Then extend the foot down until you hear a snap as the lips grip the foot.

Repeat this for all feet.

expert reply by:
1
David B

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>