Steering Stabilizer for 2007 Ford E-450

Question

Question:

I need a reflex steering stabilizer for an 07 Ford E450. what part number do I need?

asked by: Joe C

0

Expert Reply:

The correct steering stabilizer for a 2007 Ford E-450 would be the part # RM47MR.

expert reply by: Jameson C

0

Answer 1

Yes, for your 2013 Cambria 27K Class C built on a Ford E450 chassis I have a steering stabilizer that will work for you, which is the following: - Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR

view full answer...

Answer 2

I checked with Roadmaster, and the correct fit for your 2021 Ford E450 Class C RV is the Roadmaster Exact Center Steering Stabilizer #RM47MR.

view full answer...

Answer 3

I checked with Roadmaster and the Reflex Steering Stabilizer, #RM-RBK24-RSSC, will fit the 2009 Ford F-450 V10 Class B models. I have included a link to an FAQ article part of which covers steering stabilizers.

view full answer...

Answer 4

In regards to steering and keeping the wheel centered, the Roadmaster Exact Center Steering Stabilizer part #RM47MR will work great for this on a 2022 Ford E-450 Chassis. The stabilizer is basically a spring that returns the wheel to center when…

view full answer...

Answer 5

The difference between the Roadmaster Reflex steering stabilizers is how they connect to the brackets that fit onto the RV. Take a look at the pictures I attached and you can see the difference between the ends of them. #RM-RSSA has eyes on both…

view full answer...

Answer 6

On the 2003 Ford E-450 Class C with OEM steering damper you would use #RM-RBK24-RSSC that you have referenced and you would the included brackets and hardware for installation. The new steering stabilizer does not use the same factory brackets. It…

view full answer...

Answer 7

The proper Roadmaster steering stabilizer for your 2005 Ford E450 V-10 Class C Motor Home is the Roadmaster Reflex Steering Stabilizer with Mounting Brackets for Class C Motor Homes, part #RM-RBK24-RSSC. This will include the steering stabilizer,…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In regards to the Roadmaster Exact Center Steering Stabilizer part #RM47MR, the stabilizer installs on the front of the steering arm pointed down. I have attached a photo of this below. If this wasn't what you were looking for, please just let me…

view full answer...

Answer 10

The Roadmaster Exact Center Steering Stabilizer w/ Custom Brackets #RM47MR typically comes centered and you would only need to make adjustments after installation and testing to see if it continues to pull. If you adjusted it all the way out to where…

view full answer...

Answer 11

Roadmasters priority when it comes to their sway bars is top notch quality and the easiest install for the customer. This typically cuts the install time down enough that you end up saving money if you pay to have the bars installed or decide to do…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Steering Stabilizer for 2007 Ford E-450

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching