Universal Leg Kit for Thomas Payne RV Jackknife Sofas to Support Tri-Fold Couch Legs

Question

Question:

IM LOOKING FOR THE FOLDING LEGS FOR A TRI-FOLD COUCH. THE LEGS THAT WHEN THE SOFA IS BEING USED AS A BED THE LEGS UNFOLD AND GIVE EXTRA SUPPORT.

asked by: PAM T

0

Expert Reply:

The closet thing we have to what you are describing is the Universal Leg Kit for Thomas Payne RV Jackknife Sofas item # 195-000017. These are designed for RVs that don't have a pre-existing platform or frame but they would provide your tri-fold couch with extra support. They have a overall height of 11-1/2".

expert reply by: Jerred H

0

Answer 1

The bolts needed to mount the Replacement Hinge for Thomas Payne RV Jackknife Sofa #195-000109 to the floor of your 2003 Tiffin Allegro motorhome will depend on where it is being mounted. If there is not a storage compartment that they are being…

view full answer...

Answer 2

There are holes in the jackknife leg kits like part #195-000017 that are designed to allow you to run hardware through them and also through the floor of your RV. There isn't a set of install instructions I can point you towards as every…

view full answer...

Answer 3

The only brackets that we have for a Thomas Payne Jackknife sofa come in the Universal Leg Kit #195-000017 and are used for mounting them to the floor. If you are needing to mount the sofa directly to the wall then you'll need to source those…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

The torque spec for the rear U bolts on your 2019 F53 motorhome are dependent on the size. If you have 3/4 x 16 u bolts (and used a 1 1/8" socket to remove the nuts) then they torque to 250 lb-ft. If the u bolts are 7/8 x 14 (and you used a 1…

view full answer...

Answer 10

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 11

Hi Rene; I'm sure it's frustrating to have the mirror fall off, and while there are only universal towing mirrors for your 2016 Nissan Frontier, there are better ones than the clamp-on (which I also do not like). I would definitely go with…

view full answer...

Universal Leg Kit for Thomas Payne RV Jackknife Sofas to Support Tri-Fold Couch Legs

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching