Air Bag Kit that Fits 2002 Chevy Silverado 1500 LD

Question

Question:

Im looking for rear airbags to fit 02 Chevy Silverado 1500 with an in-bed turnover hitch. Does this exist?

asked by: SB

0

Expert Reply:

For your 2002 Chevy Silverado that has a B and W Turnoverball Gooseneck hitch # BWGNRK1059 installed the Air Lift LoadLifter kit part # AL57272 is a confirmed fit and would work great.

expert reply by: Jameson C

0

Answer 1

You are smart to check ahead of time on the compatibility of a rear axle air bag kit with an in-bed hitch such as the B&W Turnoverball Under-bed gooseneck #BWGNRK1059. Some air bag kits work fine with in-bed hitches but not all of them! If you…

view full answer...

Answer 2

The B&W Companion Slider Gooseneck-to-5th-Wheel Trailer Hitch Adapter part #BWRVK3400 is a direct fit for the B&W Turnoverball Underbed Gooseneck Trailer Hitch part #BWGNRK1108 that you have on your 2008 Ford F-350, there is no adapter…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 5

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…

view full answer...

Answer 8

The difference between the Firestone Dual Air Command Systems #F49VV and F46VV is the the former is only controlled by a smartphone while the latter can be controlled by a smartphone but it also comes with a Bluetooth remote so you don't have to…

view full answer...

Answer 9

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Yes, the puck system used on the 2016-2019 Chevy/GMC trucks is different than the pucks used on the 2020 and newer trucks. So you would need a 5th wheel like the B&W Companion #BWRVK3710 for your 2020 GMC Sierra 3500 with an 8' Bed. If you…

view full answer...

Answer 12

I did some checking and basically the cutout bumper is the regular factory bumper. The Curt hitch, #C15312, will fit up tighter and a little more recessed, apparently the same way the factory hitch does if it were installed. Some people like the…

view full answer...

Air Bag Kit that Fits 2002 Chevy Silverado 1500 LD

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching