Troubleshooting Brakes Not Engaging on Valley Odyssey Brake Controller
Question:
Hi there,I have a valley odyssey brake controller,the problem I am having is when the brake is depressed on my truck the brakes will not engage,but when the manual override is pulled the brakes work great,I have cleaned the 7 pin connector and tested to make sure I have power on the blue wire out of the back of the controller.When the override is pulled I have a bright light on the tester,with the brake depressed I get a gradual very dim light like there’s not enough voltage coming out of the controller or something.Any help is greatly appreciated.Thank you.
asked by: Chad R
Expert Reply:
When using a circuit tester like the # PTW2993, you won't get a reading, or at least not a correct reading, when the brake is depressed while parked. From what I have found, the Valley Odyssey brake controller is a proportional controller. A proportional brake control applies the brakes based on the deceleration of the tow vehicle, so it will not work while you are parked. The manual override will always work.
Although I do not have access to more information on the Valley Odyssey brake controller since we do not carry it, I recommend double checking the connections to make sure they are secure. It is also possible the blue wire is damaged and needs to be repaired or replaced with something like the # 10-1-1.
I have attached a helpful article on troubleshooting brake controller installations as well as a link to all of our brake controllers should you need a replacement. If you let me know what vehicle you have I would be happy to make a recommendation and let you know if a custom wiring harness is available.
Products Referenced in This Question
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Can the Curt Custom Tail Light Wiring Kit Be Used With LED Lights