Timbren Kit that Fits 2021 Toyota Tacoma

Question

Question:

Is this the same part number for Timbren TORTTN?

asked by: Michael I

1

Helpful Expert Reply:

Yes the Timbren kit part # T62FR fits your 2021 Toyota Tacoma and is same as TORTTN.

expert reply by: Jameson C

1

Answer 1

The main difference when comparing Timbren and SumoSprings for suspension enhancement is going to be the weight capacities. Timbren uses hollow rubber springs that is able to support more weight but they can cause a firmer ride. The SumoSprings are…

view full answer...

Answer 2

Here are the heights of the Timbren Severe Service kits for your 2016 Toyota Tacoma: - Timbren Suspension Enhancement System #T72FR - Total Height 4-7/16" - Rubber Spring 3-9/16" - Timbren Suspension Enhancement System #T62FR - Total Height…

view full answer...

Answer 3

I just spoke with my rep at Timbren. The height of the Timbren Suspension Enhancement System - Rear Axle Item #T62FR for your 2010 Toyota Tundra is 3 9/16 inches for the rubber spring portion and 1 5/16 inches for the bracket with a combined overall…

view full answer...

Answer 4

Those are very good questions and let's start with the capacities of both systems. The SumoSprings Solo Custom Helper Springs #SSR-612-40 has a 500 lb capacity and SumoSprings #SSR-612-47 has a 1,000 lb capacity, which means that is the highest…

view full answer...

Answer 5

Some 2021 Tacoma were equipped with 3 leaves in the springs, some with 4, so you'd just need to take a quick peek at what you have to determine which Timbren kit you'll need, as I have no way to look up how your truck is equipped. For a 4WD…

view full answer...

Answer 6

You are correct that the 7,000lb rating of the Timbren Helper Springs #T62FR and 2,800lb rating of the SumoSprings #SSR-610-54 is pretty different. For your 2021 Toyota Tundra I recommend going with the #SSR-610-54 as they are made out of a softer…

view full answer...

Answer 7

The bracket with inflation valves that you referenced does come with the Firestone Ride Rite Kit part #F2445. You can see it in the review video I attached on the table just to the right of the air bags.

view full answer...

Answer 8

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The best Timbren kit for your 2024 Toyota Tundra is the Timbren Suspension Enhancement System #T45MR rated for 6K. The Off-Road kit and the 7K kit will have the Timbren bumpers engaging a bit quicker than what you'll need with standard vehicle…

view full answer...

Timbren Kit that Fits 2021 Toyota Tacoma

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching