Is the Top Part of Rackem Spare Tire Rack for Enclosed Trailers Available By Itself

Question

Question:

Can I buy just the top part the hook holding the etrack? That way I can add a longer vertical track to it.

asked by: Rodney P

0

Expert Reply:

The top part with the hook on the Spare Tire Rack for Enclosed Trailers, # RA-16, is not available as a separate part. A lot of customers who purchase this carrier also add some additional e-track like # E19146, perhaps for exactly the same reason.

expert reply by: Michael H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 3

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 4

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 5

I am sorry I don't have any tires that are going to fit your rim. I do have a couple of comparable size tires that come in a wheel tire combo. I have listed the two below along with their lug patterns. 5 on 4-1/2 Lug Pattern - Kenda 205/65-10…

view full answer...

Answer 6

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Answer 7

Yes, the Kenda Karrier ST175/80R13 Radial Trailer Tire #AM31990 will indeed fit on the etrailer Hitch Mounted Spare Tire Carrier #e98ZR. The spare tire carrier will work with virtually any 4 lug, 5 lug or 6 lug wheel. The #AM31990 wheel uses the…

view full answer...

Answer 8

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The overall measurements of the Lippert Underchassis Double Bin Storage Unit w/ Spare Tire Carrier #LC125460 is 99-1/2 inches long overall and 23 inches wide at the mounting brackets. The length at the mounting brackets is 78 inches. Please see…

view full answer...

Answer 11

On the Lippert underchassis storage pin and spare tire mount #LC125460 the center to center distance between the mounting brackets is approximately 70-1/2 inches. I have included some links that show some additional measurements. The overall…

view full answer...

Answer 12

To determine if the Lippert Underchassis Double Bin Storage Unit w/ Spare Tire Carrier for RVs #LC125460 will be compatible with your 2014 275ULSBS Work n Play trailer you'll need to measure the chassis to ensure the mounting brackets line up…

view full answer...

Is the Top Part of Rackem Spare Tire Rack for Enclosed Trailers Available By Itself

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching