Installation and Hardware for Stromberg Carlson Folding Handrail for RVs

Question

Question:

Best video ever by etrailer but we need the accessory kit to install. We are replacing the standard folding grab handle on a 2019 GD Reflection. We have the rail, including end caps, just need the accessory kit he mentions in the video.

asked by: Becky S

0

Expert Reply:

The Stromberg Carlson Folding Handrail for RVs, # AC-530 is a complete kit, it has the needed mounting hardware. The rail and mounting hardware are not sold separately. To install, you must make sure that the rail's mounting blocks are positioned in front of a wall stud or the blocking behind the door.

expert reply by: Michael R

0

Answer 1

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 4

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 5

The only real difference between the Alpha Systems #AL74UV and the LaSalle Bristol #3441700534142711440 is that the Alpha Systems is made of TPO which is a bit less flexible than Elvaloy-based PVC that #3441700534142711440 uses; PVC is going to be a…

view full answer...

Answer 6

The two most likely causes of a MaxxAir vent fan lid not opening or closing are either going to be a lift motor or operator failure. I recommend removing the motor and applying power directly to this to see if the shaft turns. If not, you know the…

view full answer...

Answer 7

We do have the panels separately. What you're looking for is the Go Power Overlander Expansion Kit - 200 Watt Solar Panel #34282182.

view full answer...

Answer 8

Most slides have EPDM rubber roofs but because EPDM is rubber it requires treatment each year to keep it soft and prevent shrinkage. You could replace it with TPO which is another synthetic rubber that will last longer than the EPDM. The smallest…

view full answer...

Answer 9

We do have a potential solution for you, but I will tell you up front that we do not offer a direct replacement for your Direct Vent Water Heater Model SW6D. What we recommend as a replacement is the Furrion RV Tankless Water Heater #FR98SR. This…

view full answer...

Answer 10

The Go Power Overlander Expansion Kit - 200 Watt Solar Panel item #34282182 has everything you need to connect to your existing Go Power Kit with the exception of extension cables. I have listed the lengths available below: 10' Go Power MC4…

view full answer...

Answer 11

I recommend the Alpha Systems Butyl Tape for RV Weatherproofing #AL28FJ as it's 1" wide to fully cover the flange of your vent. Make sure you overlap the ends to form a tight waterproof seal. You can see me doing this at 2:50 mark in the…

view full answer...

Answer 12

The Alpha Systems Superflex TPO RV Roof Membrane #AL32CV is 30 mils thick. You will need the Alpha Systems RV Roof Replacement Installation Kit #AL74UV to install and seal the membrane on your roof.

view full answer...