Wiring Diagram For The Jensen RV Stereo System # JWM60A

Question

Question:

on my radio the yellow connects to the 12vdc battery power, the red connects to the 12vdc switch power and blue connects to the 12vdc trigger. What corresponding wires on the jwm60a would these wires connect to?

asked by: BENNY K

0

Expert Reply:

I've attached the wiring diagram for the Jensen RV Stereo - Double DIN - AUX/USB, Bluetooth, jControl - 12V # JWM60A (pictured below) which will show to the function of each wire color in the wiring harness to aid you during the installation process.

expert reply by: Kevin C

0

JWM60A Wiring Diagram
(click to enlarge)

Answer 1

As far as the necessary mounting size hole and the features provided, the Jensen #JWM60A RV Stereo you'd looked at would be the best replacement. The stereo has an AM/FM tuner, can play DVDs or CDs, is Bluetooth compatible and has aux and USB…

view full answer...

Answer 2

Most likely the stereo is fried since there isn't a fuse in this one like most other stereo systems. What you can do though is pull off the trim around it to get to the mounting screws and remove it from the cabinet. If you have done this and…

view full answer...

Answer 3

After looking up the wiring diagrams for your old RV Stereo AWM970 and your new Jensen RV Stereo #JWM60A (Jensen part number JWM62A) you new stereo should actually have 3 more wires, not less wires. The AWM970 had two connectors, a 12 pin and a 4 pin…

view full answer...

Answer 4

The Jensen Stereo #JWM60A most likely needs to be reset. The connections you mentioned are most likely causing issue if I understand correctly because you will only be able to use one input signal at any given time. If you are using the USB input,…

view full answer...

Answer 5

The yellow power wire of your RV will run to the red wire on the harness Jensen stereo part #JWM60A which is 12VDC switched. This allows the stereo to turn on at any time. The amp remote wire only needs to get ran if you have an external amp you are…

view full answer...

Answer 6

The "Amp Remote" blue wire coming from the harness for your Jensen RV Stereo #JWM60A is only used if you are needing to power an external amp. If you have an external amp you would would run this wire to it, which basically tells the amp…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

For an upgrade over the Drive stereo you have now the Jensen Stereo part #JWM60A that you referenced is our best choice. It essentially has all of the same features as the Drive while being a bit more reliable. It's designed for RV in-wall…

view full answer...

Answer 10

If you are just looking for a new converter, the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers part #PD4635V will be a direct upgrade for the Magnetek Converter Series 6300 Model 6332 that you have now.

view full answer...

Answer 11

I reached out to my contact at Jensen and he did say that your AWM975 model stereo has been out of production for a while. To replace the unit he said the best option is with the Jensen RV Stereo #JWM60A, which features the same cutout size and…

view full answer...

Answer 12

I recommend the Jensen RV Stereo #JWM60A to replace your Jensen Voyager AWM900 in your RV. This has almost identical overall dimensions (10-7/16" wide x 7" tall x 6-1/2" deep) and mounting dimensions (9" wide x 6" tall x…

view full answer...