Spacer Needed to Use Air Lift 7500 on Truck with 2 inch Lift Kit

Question

Question:

I have lift on my 2017 f250 that lifts the rear 2inch from stock will i need 2inch spacers to go under the bags on the air lift 7500xl

asked by: Mike T

0

Expert Reply:

Yes you would need 2 inch spacers with the Air Lift 7500 # AL57577 since you have a 2 inch lift. For that you'd need the part # AL52420 and you'd be set.

expert reply by: Jameson C

0

Answer 1

The Air Lift AirLift 1000 Air Helper Springs for Coil Springs will work in the exact manner you want; improving the ride and how your 2014 Ram 1500 handles when you are towing. These air springs will reduce the strain on your Ram's suspension…

view full answer...

Answer 2

I have a solution for you but no I do not have a taller air bag for the Air Lift LoadLifter 7500 XL Air Helper Springs item #AL57575. The Air Lift Universal Air Spring Spacers for LoadLifter 5000 and 7500XL item #AL52420 are 2 inch spacers. These…

view full answer...

Answer 3

In order to determine if you need to add additional lift spacers to the Air Lift LoadLifter 5000 Air Helper Springs on your Ford F-250 you will need to measure the distance between the upper and lower airbag brackets, then subtract the height of…

view full answer...

Answer 4

If the lift you installed added height to the suspension between the frame and the axle you would need a 2 inch spacer when installing the part #AL57204 with the part #AL52420 which will take up the extra space created. Since you asked where it…

view full answer...

Answer 5

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the…

view full answer...

Answer 6

The B&W Gooseneck Hitch #BWGNRK1067 is a confirmed fit on both the short-bed and long-bed versions of your 2006 Silverado 2500HD. This excellent 30K-rated USA-made hitch does NOT include the 4-inch hole saw needed for making the ball hole.…

view full answer...

Answer 7

The correct B&W Turnoverball Underbed Gooseneck Trailer Hitch for your 2018 Ford F-350 Super Duty is part #BWGNRK1116 for either bed size and whether you have a 2WD or 4WD. I'm not sure when you looked at the B&W fitguide but…

view full answer...

Answer 8

Based on the height of your truck the lowest setting is going to most likely be the correct choice when installing your B&W Companion 5th Wheel Trailer Hitch - Dual Jaw - 20,000lbs Item #BWRVK3500-5W. The point of the vertical adjustability…

view full answer...

Answer 9

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over…

view full answer...

Answer 10

The biggest difference is that from the RVK3000 to the Companion #BWRVK3500 the capacity was upgraded from 18,000 lbs to 20,000 lbs. The height adjustability also changed from 14-3/4 inch-16-3/4 inch to 16-1/4 inch-18-1/4 inch. The post that…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

view full answer...

Spacer Needed to Use Air Lift 7500 on Truck with 2 inch Lift Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching