Folding Tonneau Cover for a 2022 Honda Ridgeline

Question

Question:

I am looking for a folding Tonneau Cover for my 2022 Honda Ridgeline

asked by: Eric

0

Expert Reply:

I have a great Tonneau cover for your 2022 Honda Ridgeline. It is the BAKFlip MX4 Hard Tonneau Cover - Folding - Aluminum - Matte Finish item # BAK48602. This cover will sit inside your Honda Ridgeline's bed rails and secures upright for unrestricted bed access. The tailgate opens and closes with the cover up or down.

expert reply by: Jerred H

0

Answer 1

The 2020 Honda Ridgeline has many model Tonneau covers that fit the composite bed/box. My recommendation is the BAKFlip MX4 Hard Tonneau Cover - Folding - Aluminum - Matte Finish #BAK48602 which offers a clean matte finish that matches your…

view full answer...

Answer 2

With the BAKFlip Tonneau cover #BAK72602 for your 2917 Honda Ridgeline you do need to have the rear most panel open before closing the tailgate or it could damage the cover. But there is a cover that will allow you to close the tailgate with the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Hi Jeff; thanks for the question and sturdy is definitely a good word for the etrailer tonneau that fits your 2022 Ram 1500 with a 5-1/2 foot bed, the etrailer Hard Tonneau Cover #e35DR. It's made of a fiberglass-reinforced plastic which is a…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

I am sorry I don't have any tires that are going to fit your rim. I do have a couple of comparable size tires that come in a wheel tire combo. I have listed the two below along with their lug patterns. 5 on 4-1/2 Lug Pattern - Kenda 205/65-10…

view full answer...

Answer 12

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Folding Tonneau Cover for a 2022 Honda Ridgeline

Products Referenced in This Question

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching