What Rims do You Recommend for My 225/75-15 Tires?

Question

Question:

whats advised rim width for a radial 225/75/15 steel wheel 5on5 10 ply

asked by: Mike C

0

Expert Reply:

I did some research on your 225/75-15 tires like the # LHWL304 and discovered that the recommended width of your rims should be between 6 and 7-1/2 inches wide.

For a great wheel that fits these requirements and has a 5-on-5 bolt pattern, I recommend the Dexstar Steel Mini Mod Trailer Wheel - 15" x 6" Rim - 5 on 5 # AM20538DX. The Mini Mod wheel is constructed of steel and includes a modular design that is sturdy and corrosion resistant. This wheel is also made 100% in the U.S.A.

expert reply by: Bob C

0

Answer 1

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 2

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 3

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 4

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 5

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 6

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 7

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be totally perfect…

view full answer...

Answer 8

The Kodiak Oil Cap #KPCAP you are looking at is a replacement cap for the Kodiak Pro Lube Kit. The oil cap you need is the Redline Oil Cap, Plug and O-Ring for Dexter 7-9K Trailer Axles #RG04-230. This will replace the oil cap on your trailer axles…

view full answer...

Answer 9

For your AL-KO 7210 braking assembly, you can use the Hydraulic Brake Kit #AKFBBRK-7 as a replacement. These braking assemblies measure 12" x 2", bolts onto a 5 bolt mounting flange, will work with wheel sizes from 14-1/2" to…

view full answer...

Answer 10

The best option for a Class C motorhome windsheild cover is going to be the Adco Deluxe Cover part #290-2507 which is designed for Class C motorhomes just like yours. I attached a review video for this cover for you to check out as well.

view full answer...

Answer 11

For a replacement you need the Titan Zinc-Plated Brake Actuator #T2477600. This is the Titan Model 10 which is the same as the Dexter DX12.5 you currently have on your boat trailer.

view full answer...

Answer 12

Self-adjusting brake assemblies are the way to go like with the #AKEBRK-7-SA which do fit your 7k Dexter axles. The only real reason to go with manual adjust is really just cost. At one point the self adjusting models were much more expensive but now…

view full answer...

What Rims do You Recommend for My 225/75-15 Tires?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching