Replacement Side Support Pole for Yakima SlimShady Awning

Question

Question:

I was looking for a replacement arm for my Yakima Slim Shady 6.5 awning. Yakima gave me a part number of 8881363 and indicated that you may have the item but I could not find it on the website. Thanks!

asked by: Paul S

0

Expert Reply:

We do have the replacement side support pole for the Yakima SlimShady Awning 8881363 with the part # Y42AR.

expert reply by: Jameson C

0

Answer 1

Yes, the Yakima SlimShady Awning #Y36VR that you referenced does comes with lock cores built into the clamps that attach to the crossbars.

view full answer...

Answer 2

The Yakima SlimShady part #Y36VR that you referenced is designed to provide shade as well as block rain.

view full answer...

Answer 3

An awning like the Yakima SlimShady #Y36VR can be mounted directly on your LoadWarrior. However, there are no brackets that will allow you to mount it on the side. Brackets like the #Y84AR you were looking at are designed to fit in T-slots so they…

view full answer...

Answer 4

The Yakima SlimShady Awning, #Y36VR has clamps that mount to the cross bars of your roof rack. It can be mounted to either driver or passengers side but does not swivel to mount of the back of the vehicle. You can however add the Rightline Gear SUV…

view full answer...

Answer 5

While there isn't a mosquito net for the Yakima SlimShady part #Y36VR that you referenced the very similar Thule Tepui Tent part #TH8002AW604 does have one available with the part #TH8002X1001. The Tepui is a similar size roof rack mounted…

view full answer...

Answer 6

Our best swing away cargo box is the Yakima EXO System with 2 Enclosed Cargo Carriers, part #Y74ZR. This adds 20 cubic feet of storage to the rear of your RV and works with Class III and Class IV 2 inch trailer hitch receivers. This…

view full answer...

Answer 7

The poles of the Yakima SlimShady #Y36VR range from 4 to 7 feet. Yes, the legs can be set at any height within that range. This will accommodate vehicles that are taller or shorter or give you the option to slant the SlimShady to block the sun.

view full answer...

Answer 8

I have a solution for you, but those parts are not available from Yakima at this time. Instead, you'll need to replace the entire assembly on your Yakima Slim Shady Awning #Y36VR. You can use the Replacement Clamp Assembly for Yakima…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Side Support Pole for Yakima SlimShady Awning

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching