Hose Inner Diameter for MB Sturgis High Pressure Propane Hose 3/8" MPT x 3/8" Female Flare Swivel

Question

Question:

What is the ID on this hose?

asked by: George R

0

Expert Reply:

The MB Sturgis High Pressure Propane Hose # 100040-48-MBS has a 3/8" inner diameter for the hose.

expert reply by: Jon G

0

Answer 1

It sounds like you are just needing a hose assembly like the MB Sturgis Propane Hose #100383-48-MBS. This 4 foot long hose is designed to connect a 2-stage regulator to the RV's propane system. It features a 3/8 inch Male NPT at one end that will…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

For some reason Toyota isn't very forthcoming with how to figure out if you have the tow package or not. From my understanding all of the V6 models of the 2019 Toyota Highlander have the tow package but it isn't specified as to what else…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Hey Floyd, great question! According to my research I do believe all of the 2019 Toyota Highlanders equipped with a V6 also have the tow package so the Curt T-Connector #56042 would be the wiring harness you need. Toyota doesn't make it easy…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

This Hopkins wiring harness does fit your 2019 Toyota Highlander. Since the location of the factory wiring is located inside the car and not under/behind the bumper, you will likely be limited to the current location of the wiring. That being said,…

view full answer...

Answer 10

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 11

The most likely cause of the "no signal" error you are receiving with the Furrion Vision S Wireless RV Backup Camera System part #FOS43TASF is due to an interruption on the camera's power wire. Make sure that the camera is receiving…

view full answer...

Answer 12

The inside dimensions of the Malone Profile18S Rooftop Cargo Box #MPG910 are 76" long x 30" wide x 14-1/2" tall.

view full answer...

Hose Inner Diameter for MB Sturgis High Pressure Propane Hose 3/8" MPT x 3/8" Female Flare Swivel

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching