What Coupler Lock will Fit My Jayco Jayflight Trailer?

Question

Question:

Hello: I recently bought a hitch lock that indicated it would fit a Jayco Jayflight but the lock did not fit it was close. I have a 2022, Jayco Jayflight, 31. Can you help me find a hitch lock that will fit? Thanks for your help

asked by: Thomas R

0

Expert Reply:

For a lock that fits all three standard ball sizes, I recommend the Master Lock 1-7/8", 2", and 2-5/16" Trailer Coupler Lock # ML377KA.

expert reply by: Bob C

0

Answer 1

I have a solution for you but the etrailer Hitch and Coupler Lock Set - 2" Hitch - 2-5/16" Ball item #e68ZR slides onto a standard coupler and most likely won't work on yours if it has a wider coupler and a larger rolled lip than in the…

view full answer...

Answer 2

The etrailer.com Coupler Lock #e98893 fits standard lipped couplers for 1-7/8-inch and 2-inch hitch balls up to a maximum width (including the lip) of 3-3/4-inches. Instead you can use our Coupler Lock #e98895 for 2-inch and 2-5/16-inch balls since…

view full answer...

Answer 3

We do have the etrailer coupler lock #e98895 which is made to fit a flat lip coupler up to 4-1/2" wide. This may be a very tight fit if you are right at 4-1/2". If you want to avoid any potential fitment issues, I recommend the Master Lock…

view full answer...

Answer 4

The 1/2" Trimax Dual Purpose Coupler Lock #TMX77FR measures 4" across to the U-Shaped locking pin. We also have the 9/16" Trimax Dual Purpose Coupler Lock #TMX67FR and Trimax Dual Purpose Coupler Lock with Ballistic Grade Nylon Housing…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

What Coupler Lock will Fit My Jayco Jayflight Trailer?

Product Page this Question was Asked From

Continue Researching