Can Wheel Masters 2-Hose Inflation Kit WM8007 Fit Sprinter RV

Question

Question:

will these work on our sprinter rv?

asked by: Jennifer M

0

Expert Reply:

Yes the Wheel Masters 2-Hose Inflation kit part # WM8007 could be used on a Sprinter RV that has a dually wheel setup with hand holes and wheel diameters between 16 and 19-1/2 inches.

expert reply by: Jameson C

0

Answer 1

The Wheel Masters Tire Pressure Valve Extenders - 180-Degree Bend - Aluminum Rear Wheels - Qty 2 #WM8029180 are a great option but for a little more accessibility it sounds like you'd prefer something more like the Wheel Masters 2-Hose Inflation…

view full answer...

Answer 2

I do have an installation video of the Wheel Masters 4-Hose Inflation Kit part #WM8208 but keep in mind that the kit is more or less universal and not every wheel it will be installed on is the same so your application could vary. That said, the…

view full answer...

Answer 3

Wheel Masters 4-Hose Inflation Kit #WM8208 and #WM8008 can be used with rubber valve stems. They are only increasing the length of the stems making them easier to access. They do not put any additional stress on the valve stems so they would work for…

view full answer...

Answer 4

For your 2018 Sunseeker 2800 on E-450 Cutaway, I recommend the Wheel Masters Airless 4-Hose Inflation Kit - 16" to 19-1/2" Dually - Wheel Cover Mount #WM8208. These will fit your 16 inch wheels and the wheel liners/covers. If you look at…

view full answer...

Answer 5

For the inner wheel of your dual rear wheels I recommend the Wheel Masters 2-Hose Inflation Kit - 16" to 19-1/2" Inner Dually #WM8009. These valve extenders are designed to mount into the handholes of your wheels (pictured below) for an…

view full answer...

Answer 6

The Wheel Masters 2-Hose Inflation Kit #WM8001 is designed to fit steel or aluminum rear wheels with wheel liners. For your 2022 Mercedes-Benz Sprinter 3500 you can use the #WM8009 instead. These are designed to fit wheels without wheel liners or…

view full answer...

Answer 7

You were on the right track- the Wheel Masters 2 Hose Inflation Kit #WM8009 are designed for 16" to 19-1/2" wheels like the ones on your Winnebago Access and will work with TPMS systems. The 7-1/2" hose length is going to supply you…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Can Wheel Masters 2-Hose Inflation Kit WM8007 Fit Sprinter RV

Product Page this Question was Asked From

Continue Researching