Can I Replace a Marshall Model 250 Regulator With a Mr. Heater Model F273719 Regulator

Question

Question:

In my Jayco Feather Ultralite X17 Z, Can I replace a Marshall Model 250 regulator with a Mr. Heater Model F273719 Regulator

asked by: Erick S

1

Helpful Expert Reply:

I have an option for you but the Mr. Heater Model F273719 regulator will not be a replacement for the Marshall Model 250 regulator. From my research, I found the Marshall 250 is an automatic change-over two-stage regulator. The Mr. Heater Model F273719 is not an automatic change-over two-stage regulator, it is made for 1 tank while the Marshall 250 is made to use 2 tanks.

The option I have for you is the Camco Automatic Changeover 2-Stage Propane Regulator for Dual Propane Tanks # CAM59005. The Camco # CAM59005 is the automatic change-over two-stage regulator you need to replace your Marshall Model 250 regulator.

expert reply by: Thomas M

1

Answer 1

The center pin of a 7-way is typically used as the reverse light circuit. Not every trailer towing setup requires this circuit to be active so in a lot of cases we see this circuit left unconnected. I attached a diagram of a 7-way for you to check…

view full answer...

Answer 2

Thanks for the picture! To replace your Marshal 605H propane regulator you will need to go with the Camco Vertical 2-Stage Propane Regulator #CAM59313. This will be an exact replacement for your current regulator. I included a video review of the…

view full answer...

Answer 3

The best replacement option we have for your Marshall 605H LP Regulator is the Automatic Changeover RV LP Gas Regulator #37207-30395 that you were already looking at. This auto-changeover regulator comes with a small indicator on the front of it to…

view full answer...

Answer 4

Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter you'd want the #GY58GR that you referenced.

view full answer...

Answer 5

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Yes, the Automatic Changeover RV LP Gas Regulator #37207-30395 will work to replace your Winntec 6020. This regulator uses the same sized fittings as your 6020 and the BTU rating of this is compatible.

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 10

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 11

Your Winntec 6020 regulator can easily be replaced by the Automatic Change Over RV Regulator from JR part #37207-30395 as the BTU rating of this is compatible and the fitting sizes are the exact same.

view full answer...

Answer 12

The fan in the #PD4645V is temperature controlled so typically it does not run continuously. However, if there are heavy loads you can expect the fan to run non-stop. According to Progressive Dynamics, this can also happen if you're charging…

view full answer...