Recommended Ceiling Garnish Compatible with MaxxAir Roof Vent 4501K

Question

Question:

Hey guys which garnish ring will fit a max fan 4501k? Application- 2021 Renegade 45 CME Thanks

asked by: Pete W

1

Helpful Expert Reply:

The ceiling garnishes like the MaxxAir Maxxfan RV Roof Vent - White item # MA54FR you were looking at are universal. So long as you have the standard 14"x14" opening for your MaxxAir 4501k this garnish will be able to fit. It may require some trimming to match your ceiling depth.

expert reply by: Jerred H

1

Pete W.

11/11/2021

Thanks Jerred for your help. My garnish ring is 16 1/4 x 16 1/4 from outside edges and the inside edge is approximately 13 1/2 x 13 1/2 . This measurement is installed and looking at the ceiling. Will the MA54FR still work? Thanks again

Reply

Les D.

11/15/2021

@PeteW Yes the MA54FR will work.

Reply

Answer 1

Since you have a MaxxFan on your Winnebago Travato the garnish part #MA54FR that you referenced would fit and work well.

view full answer...

Answer 2

It sounds like you're looking for a replacement ceiling garnish for your MaxxAir MaxxFan RV roof vent. If that's what you're after, we have the Ceiling Garnish for MaxxAir MaxxFan RV Roof Vent #MA54FR. This garnish will fit…

view full answer...

Answer 3

When it comes to trimming The Ceiling Garnish for MaxxAir MaxxFan RV Roof Vent #MA54FR you will need to use masking tape to mark where you want to make your cut on the garnish. You will then need to use a hand saw to cut along the masking tape. I…

view full answer...

Answer 4

The Ceiling Garnish for MaxxAir Maxxfan RV Roof Vent - Black #MA10-20209 is designed to fit in 14" x 14" rough vent cutout dimensions and the plastic garnish itself is roughly 1/4" thick. The outer diameter of the flange body will be…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 8

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 9

Hello John. The #C96JR tail light kit for the 2023 Jeep Gladiator will indeed work with a Brake Buddy brake System Such as part #HM39524. So, if you plan to use a portable brake system, that is definitely what I recommend, and you do not need to get…

view full answer...

Answer 10

The 15,000 Btu Furrion air conditioner is what I would recommend and what I have on my trailer. Since it is an enclosed trailer I'm guessing you want the manual distribution box. You can choose from the following based on color: -Furrion Chill HE…

view full answer...

Answer 11

Yes, the Portable Power Watchdog Surge Protector #HU67FR is the Hughes part number PWD-30-EPO.

view full answer...

Answer 12

The instructions for the Replacement Side Plates #DM49GV which fit the Demco Autoslide 5th Wheel Trailer Hitch 18K #DM79GV or 21K #DM29GV are not very helpful. I have linked them below for your verification but the 1/2" grade 5 bolts are…

view full answer...

Recommended Ceiling Garnish Compatible with MaxxAir Roof Vent 4501K

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching