Replacement Control Board For Atwood G6A-8E 6 Gallon LP DSI Water Heater

Question

Question:

Do you sell Dinosaur brand control boards for the Atwood g6a 8e hot water heater

asked by: Joe

0

Expert Reply:

We do have the Replacement Control Panel for Atwood Water Heaters # AT91367 for your Atwood G6A-8E.

We do not carry the Dinosaur brand control panels.

expert reply by: Bud M

0

Answer 1

Yes, if you have the Atwood/Dometic RV Water Heater (G6A-8E) then the correct replacement circuit board for you is the Replacement Control Panel for Atwood Water Heaters part #AT91367.

view full answer...

Answer 2

We have previously confirmed with Dometic (who own Atwood now) that the Atwood 91349 that you've got can be replaced by the Replacement Control Panel for Atwood Water Heaters #AT91367 you were looking at.

view full answer...

Answer 3

It sounds like this has been an issue that started intermittently and has progressed to a full on malfunction. There are a couple of things that could be going on here; this could be as simple as the thermocoupler going bad, bad thermostat or the…

view full answer...

Answer 4

I looked up the parts breakdown of the Atwood GH6-8E Water Heater and it shows that the correct replacement control panel is the Replacement Control Panel for Atwood Water Heaters part #AT91367 so that is what I recommend using. I'm not sure why…

view full answer...

Answer 5

view full answer...

Answer 6

The number 96220 is the OEM part number of the discontinued Atwood G6A-8E Water Heater AT96121 and we do have the correct circuit board (control panel) for that. The part you need is the Replacement Control Panel for Atwood Water Heaters #AT91367.

view full answer...

Answer 7

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 12

From my research it looks like you may have a pin box compatible with the 1621 bolt pattern. If so, then the Reese Goose Box #RP85FR for 20K capacity will give you the connection to your gooseneck along with the air ride comfort but will not give you…

view full answer...

Replacement Control Board For Atwood G6A-8E 6 Gallon LP DSI Water Heater

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching