Wind Deflector that Fits Erickson Ladder Rack # EM07707

Question

Question:

Erickson Over-The-Cab Truck Bed Ladder Rack - Steel - 1,000 lbs Item # EM07707.... I purchased this ladder rack from your company and just wondering will the buyer wind deflector fit my erickson rack?

asked by: Craig S

0

Expert Reply:

Yes the Wind Deflector part # 3371501193 will fit the Erickson ladder rack part # EM07707 that you referenced.

expert reply by: Jameson C

0

Answer 1

For a programmer that will boost your 2010 Ford Expedition's horsepower and offer better fuel economy, I recommend the Edge EvoHT2 Hand-Held Performance Tuner #EP16040. For the version of this tuner that is California approved, you will want part…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

Though there isn't a mesh available there is absolutely an air deflector for the Buyers Products Over-The-Cab Truck Bed Ladder Rack - Aluminum #3371501400 or Black #3371501410. The Wind Deflector Kit for Buyers Products Truck Bed Ladder Rack…

view full answer...

Answer 5

I went out into our showroom and measured the dimensions of a set of discontinued Thule square load bars and found that they are 7/8 of an inch by 1-1/4 inches. This is identical to the Inno square bars like #INB137.

view full answer...

Answer 6

If you are not experiencing sag then you can start with just the Reese Friction Sway Control Kit part #83660 and the Reese Sway-Control Bracket for 2" Ball Mounts part #RP26003. There is no good way to attach this other than welding to avoid…

view full answer...

Answer 7

I spoke to Dexter and they said there is a bit of a process for installing the spindle nut properly. 1. You will need to thread on the inner nut, rotate the hub, then tighten the nut to 100 foot pounds. 2. Loosen the nut to remove the torque, making…

view full answer...

Answer 8

It sounds like you have a common phenomenon known as "hyperflashing" occurring on your truck. The reason your LED lights are flashing is because the LED lights draw such little power that your turn signal relay sees the bulbs being out. The…

view full answer...

Answer 9

I recommend the Buyers Products Over-The-Cab Truck Bed Ladder Rack part #3371501150 for the 2019 Chevy Silverado 1500 with 6-1/2 ft bed. It also fits the 5-3/4 ft bed and 8 ft bed. The Buyers Products over-the-cab rack has an easily removable rear…

view full answer...