How to Use Single Inflation Valve for Air Lift Air Bag Kit

Question

Question:

Is there a T fitting to combine both air lines to fill both air bags at the same time from one fitting?

asked by: Chris L

0

Expert Reply:

You'd just need a union tee like the part # AL21838 to allow the Air Lift kit part # AL88341 to be inflated by a single valve.

expert reply by: Jameson C

0

Answer 1

The Air Lift LoadLifter Air Springs W/ internal bumpers part #AL88341 is the best option for suspension enhancement in the 2020 GMC Sierra 2500 with a fifth wheel hitch installed, to take some of the strain off the factory suspension and prevent…

view full answer...

Answer 2

The biggest pro to using one valve stem to maintain air pressure in an air bag kit is that you always know that both bags will have an equal amount of pressure in them. If you have an application where equal pressure on both sides is always the norm…

view full answer...

Answer 3

No, the minimum air pressure is 5 psi and the maximum is 100 psi. The 40 figure comes into play based off of the instructions which state that generally the system can support 40 pounds per 1 psi of air pressure. I have linked the installation…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 10

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 11

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 12

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

view full answer...

How to Use Single Inflation Valve for Air Lift Air Bag Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching