Dimensions of 8542526002 Replacement Crossbar For Thule TracRac SR/TracONE Ladder Racks

Question

Question:

What is the length of part #8542526002?

asked by: Bryan R

1

Helpful Expert Reply:

The Thule # 8542526002 Replacement Crossbar for TracRac SR or TracOne Ladder Racks measures 69-1/2 inches in length, is 4 inches in width and is 1-1/2 inches tall, as shown in the provided photo.

expert reply by: Mike L

1

Dimensions of 8542526002 Replacement Crossbar for Thule TracRac SR/TracONE Ladder Rack
(click to enlarge)

Answer 1

I have attached a parts breakdown of the Thule TracRac TracONE Ladder Rack part #TH27000XT-EX. Can you please tell me exactly which part(s) you are referring to? If you just need a single upright post then you can use the Replacement Modular Upright…

view full answer...

Answer 2

To replace the broken tower leg on your Thule TracRac TracONE Truck Bed Ladder Rack #TH27000XTB we have the following parts: (Part #28) Replacement Modular Upright #TA8523446002 (Part #13) Replacement Modular Base #TAPT-27008-02 (Part #7) Replacement…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Dimensions of 8542526002 Replacement Crossbar For Thule TracRac SR/TracONE Ladder Racks

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching