Parts Needed to Allow Gray Water and Black Water to Dump From the Same Valve
Question:
I have a gray tank with the #T1001C valve. I have a sewer adapter like #F02-3112CL. At the moment I have adapters on both ends that let me use a 3/4inch hose in between. But with this setup it takes far too long for the tank to drain. Is there a 1-1/2inch hose available with appropriate adapters or a 3inch hose with appropriate adapters that will go between the valves 1-1/2inch MPT connection and the sewer adapters 3inch bayonet connection? Would it help to replace the 1-1/2inch MPT connection on the valve with #T1006-1 or similar?
asked by: Rick M
Expert Reply:
It sounds like you might want to have a look at the Bristol Double RV Waste Valves - Elbow - Rotating - 3" and 1.5" Hubs to 3" Lug # 34466ND13AAR, which would allow you to dump your black and gray water tanks from the same hose. This elbow fitting connects to the 3" hub on your black water drain pipe and the 1-1/2" hub on your gray water tank, and allows you to use the # F02-3112CL with your 3" spigot connection hose.
You'll need to remove your old valves to install the Bristol Double RV Waste Valve # 34466ND13AAR, and use some Valterra ABS Solvent Cement - 1/4 Pint # A05-0303 to secure the pipes together. This would allow you to use all of your existing hoses and adapters and is a great solution to dump everything from one valve.
Products Referenced in This Question
LaSalle Bristol RV Waste Valves - Elbow - Rotating - 3" and 1.5" Hubs to 3" Lug
- RV Waste Valves
- Sewer Elbow
- Double Waste Valve - Manual
- 1-1/2 Inch Hub
- 3 Inch Hub
- Rotating Valve
- LaSalle Bristol
more information >
Valterra ABS Solvent Cement - 1/4 Pint
- RV Sewer Hose Fittings
- Sewer Seals and Gaskets
- ABS Cement
- Valterra
more information >
EZ Coupler 4-in-1 Threaded RV Sewer Adapter with 90-Degree Elbow Fitting - Clear
- RV Sewer Hose Fittings
- Sewer Adapters
- Sewer Elbows
- 90 Degree Angle
- Sewer Hose Adapters
- Bayonet
- Sewer Hose to Dump Station
- 3 Inch Diameter
- 3 Inch Diameter
- 3-1/2 Inch Diameter
- 4 Inch Diameter
- Clearview
- EZ Coupler
more information >
Product Page this Question was Asked From
Valterra Waste Valve for RV Gray Water Tank w/ Cap - 1-1/2" Diameter - Hub to Male Thread
- RV Waste Valves
- Straight Valve
- Single Waste Valve - Manual
- 1-1/2 Inch Valve Body
- Stationary Valve
- Valterra
more information >
Continue Researching
- Q&A: Drain Hose to Use With the Valterra 1-1/2" Waste Valve for RV Gray Water Tank With Cap
- Q&A: Comparing Ford OEM Reese 18k 5th Wheel Hitch to Other Factory Puck Options
- Q&A: Replacement Converter for Model 7355 on a Fifth Wheel Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Correct Replacement Arm for Solera V000436372 Awning
- Q&A: Are Trailer Scissor Jacks Made for Leveling or Stabilizing a Trailer or Both
- Q&A: Does RV Need to Have Dual Stage Regulator or Can Single Stage Work
- Q&A: Recommended Waste Valve And Drain Hose Attachments For A Grey Water Tank
- Article: Cleaning Your RV Gray Water Tank in 5 Easy Steps
- Article: Trailer Couplers
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Towing a Trailer? Let's Talk About Brake Controllers