Mounting Directions For a 2-Wire RV Propane Gas And Carbon Monoxide Detector

Question

Question:

Can this be mounted vertically as well as horizontally?

asked by: Emily

0

Expert Reply:

The 2-Wire RV Propane Gas and Carbon Monoxide Detector, # RS34FR can be mounted vertically or horizontally. This should be installed within 4”-18” (10cm-46cm) of the floor as propane is heavier than air where alarm vents are not obstructed to airflow.

Please note the linked installation instructions.

expert reply by: Michael R

0

Answer 1

Since the Atwood LP DOB 31013 is no longer available, your best option is to do a full replacement. I recommend going with the: -RV Propane Gas and Carbon Monoxide Detector #RS34FR for white, or the: -RV Propane Gas and Carbon Monoxide Detector…

view full answer...

Answer 2

The Atwood 31013 is no longer made. The best choice for replacement is the RVCO #RS34FR which mounts flush against the wall, and the overall measurements are 4-1/4" square, and it sticks out 1/2" from the wall. Works with 2-wire…

view full answer...

Answer 3

Yes, the RV Propane Gas and Carbon Monoxide Detector #RS34FR can be used to replace your 3-wire Atwood Detector. The third wire is just an extra power supply wire in case your first power source were to be depleted. Most likely you have power…

view full answer...

Answer 4

See the linked item below for my recommendation: **2-Wire RV Propane Gas and Carbon Monoxide Detector - 12 Volt - White #RS34FR. The three wires are two red and one black. Black is ground and the red are for power. Only one red is needed however as…

view full answer...

Answer 5

When installing the Deka Battery Isolator - 120 Amp #DW08771 you actually do not tap into the ignition systems. Instead you will run the wire from the alternator to the A post on the Isolator, then run a wire from the number 1 post of the isolator to…

view full answer...

Answer 6

Battery isolator #DW08771 will have connection posts for each battery and for an alternator. The main battery will connect to position one and the alternator to the A post. The second battery will attach to the 2 via a circuit breaker that is rated…

view full answer...

Answer 7

I went on Deka's website and found a wiring diagram I have attached below. To install the Deka Battery Isolator item #DW08771 you will want to follow these steps: Terminal 1 would connect to the positive battery terminal of the main battery. The…

view full answer...

Answer 8

For your battery isolator similar to #DW08771, you will have connection posts for each battery and for an alternator. The main battery will connect to position one and the alternator to the A post. The second battery will attach to the 2 via a…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

I recommend the #RS34FR to replace your current LP gas detector. This is a simple 2 wire design making for easy installation.

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

The best air bag kit for your 2022 Ford F-350 that has a single rear wheel axle is the part #F95FV which has the 5,000 lb capacity you are wanting. Firestone bags are superior Air Lift bags. The ply rating of the rubber is higher, the attachment to…

view full answer...

Mounting Directions For a 2-Wire RV Propane Gas And Carbon Monoxide Detector

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching