Where Does the Tekonsha Wiring Harness 118344 Install on a 95 Ford E-150 Econoline?
Question:
Vehicle 1995 Ford E150 Econoline. My tail light has 3 three separate bulb sockets. One for reverse one for brake/running lights and one for turn signal. Which socket do I plug the harness into? This kit only has one connection for each side. Or is there a connection on the main wiring harness? Thanks
asked by: Daniel
Expert Reply:
To get the Tekonsha # 118344 installed on your 1995 Ford E-150, you will need to disconnect the center black wiring harness connector from the tail light assembly, being careful not to damage the locking tabs. Plug the T-Connector between these separated halves and you will be good to go. I know this sounds like one is being left out, but it will get your lights working properly on your trailer.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement Leaf Spring for 2021 Grand Design Imagine 3250BH
- Q&A: Complete Tow Package For A 2024 Kia Telluride LX
- Q&A: Replacement Leaf Spring for a Dexter 072-097-00
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Wire a Replacement 7-Way for a Gooseneck Trailer
- Q&A: Recommended Replacement Jack for Brenderup Horse Trailer
- Q&A: Can Trailer Brakes Be Manually Applied with Tow-Pro RED24FR Liberty Brake Controller
- Q&A: Air Lift Air Spring Fit for 2020 Ford F-350 Tremor Package
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Install a Trailer Hitch