Cleaner for Awning Fabric of RV

Question

Question:

Whats the best way to clean it?

asked by: Eric A

0

Expert Reply:

We actually have an cleaner made specifically for awning fabric with the RV Awning Cleaner part # BE62FR which removes mold, dirt, and mildew.

expert reply by: Jameson C

0

Answer 1

I wish we had exactly what you are looking for but all of our replacement awning fabrics are constructed of 13.5-oz vinyl. The vinyl may not have the look you are after but it is truly the best option in regards to durability. They are rated for cold…

view full answer...

Answer 2

If your current awning is a 16' awning you can use the replacement #LCV000334402 you were looking at. This is compatible with Solera, Dometic A&E, and Carefree of Colorado awnings. Dometic makes the Sunchaser Awning Model #834AV17.401. That…

view full answer...

Answer 3

The Never Fail Bushings were discontinued because they didn't sell as good as they thought they were, they were also having problems with the product. The bronze bushings wear out and start to crack from friction, age, heat, and from exposure…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

To correctly measure a leaf spring, you'll want to jack the trailer up on jack stands so the axle is hanging freely, then measure directly across from the center of one spring eye to the other, as shown in the provided diagram. The height of the…

view full answer...

Answer 7

I contacted MORryde and this does happen from time to time as the weight of the trailer can spread out the axles due to downward pressure on the springs/suspension. Odds are the 35" wheel base #MR27ZR will be the correct one for you, but they…

view full answer...

Answer 8

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 9

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind and…

view full answer...

Answer 10

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

view full answer...

Cleaner for Awning Fabric of RV

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching