How to Install Dexter Over-Under Conversion Kit on 2021 Grey Wolf 19SM
Question:
When installing the kit, how do you precisely re-align the axle to ensure you are installing in the correct position? If the new spring seats are to be welded to the axle, I want to be sure they are in the right place before welding.
asked by: Karen K
Expert Reply:
The process for installing the Dexter # K71-384-00, and specifically the new spring seats, is outlined in the instructions. You can tack weld the new spring seats into place once this process has been completed but it will level out the installation plate and spring seat and allow you to make sure the kit is installed properly.
I've linked the installation instructions to this answer for you to have a look at, as well, but the process for this is outlined in steps 8 and 9 on the instructions sheet.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 2-3/8 Inch
- Single Axle
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Raise Your Travel Trailer Height
- Article: Trailer Tire Sizing
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Q&A: How to Raise a 5th Wheel Trailer so it Rides Level
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions for the MORryde ALLTREK 4000 Suspension Kit
- Q&A: Double Eye Leaf Springs For Tandem Axle Trailer With 10,500LB Rating and 24" Length on Spring
- Q&A: Does MORryde ALLTREK 4000 Cushioned Equalizer Sit Taller to Offset for Additiona Suspension Movement
- Q&A: Can 3,500 lb Axle Trailer Leaf Spring 25-1/4 inch get Replaced with 5k Rated Spring
- Q&A: What Leaf Spring Width SHould be Used with Dexter Over Under Kit # K71-384-00
- Q&A: Would Dexter 3,500 lb Axle Made in 1999 Use Same Hubs as Current