Availability Of Replacement Circuit Board For Atwood Water Heater GC6AA-9E

Question

Question:

is this control board still available If not, what is the proper replacement control board for an Atwood GC6AA-9E

asked by: Doug

0

Expert Reply:

We have just what you are looking for!

Your Atwood Water Heater GC6AA-9E uses circuit board 93257 as you mentioned. Since that circuit board is no longer available you will need the Replacement Control Panel for Atwood Water Heaters # AT91367 instead.

I included a video of the # AT91367 for you to take a look at.

expert reply by: Samuel C

0

Answer 1

From what I could find out about your current circuit board, the Atwood Replacement Control Panel #AT91367 will be a direct replacement.

view full answer...

Answer 2

The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.

view full answer...

Answer 3

I believe the Replacement Control Panel for Atwood Water Heaters #AT91367 is what you are describing. You may also need the Replacement 4-Wire Control Harness for Atwood Water Heaters #AT93312.

view full answer...

Answer 4

Your 641915.301CO on your 2011 Forest River R-Pod is a Dometic Penguin II air conditioner. Currently the only cover we have for it is a Vinyl Adco RV Air Conditioner Cover #290-3016. This is not the hard shroud but a vinyl protective cover that can…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 8

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 11

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Availability Of Replacement Circuit Board For Atwood Water Heater GC6AA-9E

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching