Can Leg on 4000 lb Powered Trailer Jack Be Replaced

Question

Question:

I bent the leg on my 4000 pound electric jack can I replace it

asked by: Chris

0

Expert Reply:

If it's the drop leg like # BD500190 that's bent, you certainly can replace it if it's not bent to the point where you can pull the pin and slide the drop leg out. The # BD500190 would be the proper replacement for a Bulldog # BD500185, # BD500187, and # BD500188 powered A-Frame jack, or a jack that would accept a 1-3/4 inch diameter drop leg.

If the leg that's bent isn't removable, then you'll need to replace the jack. I'd recommend the Bulldog # BD500199 which has a 4000 lb lift capacity like your existing jack.

I've linked you to a product demonstration video for the # BD500199 powered trailer jack.

expert reply by: Mike L

0

Answer 1

The closest thing we have to a 2" x 2" bumper is the Rubber Bumper for Enclosed Trailer Ramp Door #37210715 you looked at. This has a 2-1/2" diameter with a height of 1" and a 3/8" mounting hole.

view full answer...

Answer 2

If you already have a seal that you're replacing then you want to get a seal that's a similar size, otherwise if it's a brand new application then I recommend trying to find the depth of the gap and choosing a seal slightly taller since…

view full answer...

Answer 3

The Bulldog Powered Drive Trailer Jack #BD500199 grounds through the mounting hardware. I would recommend running a jumper wire from the mounting flange of the jack to the ground wire on your trailer wiring to see if you can get it to work that way.…

view full answer...

Answer 4

I do have an option for you but the handles included with the Cam-Action Lockable Door Latch Kits like part #PLR658-SSP must be welded to the pole as there are no other options to attach them. If you can get away with a 55" long pipe then you…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...