How To Find Correct Replacement Pitch Arm for Solera Awning

Question

Question:

It is a 21foot awning on a 2020 Jayco Jay Feather. Need to replace both pitch arms. Is there a model # somewhere on the awning for ordering the correct one? Thank you!

asked by: Gregory M

0

Expert Reply:

The best way to determine the correct replacement pitch arm for a Solera awning would be measuring. The part # LC74VR measures 78", the part # LC67VR measures 63", and the part # LC375994 measures 69". If you have another length please let me know what that is and I will see if we have another replacement for this.

expert reply by: Conner L

0

Answer 1

It sounds like you're referring to the pitch arm for your awning. If that's the case then you'll need to measure your support arm, the wall mount portion in particular. The Replacement Pitch Arm for Solera XL Flat RV Awnings part #LC67VR…

view full answer...

Answer 2

You're right that was an incredibly tiny diagram; so tiny that I couldn't make anything out, unfortunately. So in order to determine if the Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm - Black #LC67VR will…

view full answer...

Answer 3

To order the correct Solera replacement arm size, simply measure the length of the wall-mount extrusion from top to bottom. I've pointed this out using the photo you sent in as an example. Short styles will measure 61-1/2" and use part…

view full answer...

Answer 4

You will want to measure the length of your current Solera awning pitch arms and match up the correct size on the link I attached for you. Based on the photo you attached, you will likely need one of the following sizes: -Replacement Pitch Arm…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

Yes, the Replacement Short Arm Assembly for RV Awnings part #LC404523 is correct for a Solera V000436372 Awning.

view full answer...

Answer 11

Hey David, actually what is going to make the biggest improvement in handling and stability for your 2011 Itasca is an upgraded rear sway bar with the part #RM-1139-175. I know that's not what you asked about but for motorhomes where most of the…

view full answer...

Answer 12

I attached a picture I got from Lippert that has their install instructions and diagnosis page for the #LC375994 that you referenced.

view full answer...

How To Find Correct Replacement Pitch Arm for Solera Awning

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching