How Does Replacement Rear Lighting Harness # 8880162 Install
Question:
I tested the rear left light on the right side and it worked, so I purchased this from you. How to install it in the 66inch Rack and Roll trailer I bought from you?
asked by: Jonathan C
0
Expert Reply:
You'll need to remove the ring terminal screws that hold the white wires of the # 8880162 to the trailer but then the other connections simply plug into the female matching end on the trailer since it uses bullet connectors.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Rear Lighting Harness for Yakima Rack and Roll Trailer
- Accessories and Parts
- Trailers
- Watersport Carriers
- Roof Rack on Wheels Parts
- Watersport Trailer Parts
- Wiring
- Rack and Roll
- Yakima
more information >
Continue Researching
- Q&A: Will Heavy Duty Shocks Fit Yakima Rack and Roll Trailer 66" Trailer
- Q&A: Can Heavy Duty Shocks be Put on the 66 Inch Rack and Roll Trailer
- Q&A: Are the Yakima Rack and Roll Trailer Crossbars Plastic or Metal
- Q&A: Recommended Rack and Roll Trailer for Kayaks and Bikes
- Q&A: Replacement Wiring Harness and Lights for Yakima Rack and Roll Trailer
- Q&A: Yakima Rack and Roll Trailer Solution for Transporting 5 Kayaks Economically
- Q&A: Where to Find VIN Number on Yakima Rack and Roll Trailers
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV