What Replacement Tonneau Cover Do I Need for My TruXedo Lo Pro # TX539801?

Question

Question:

Hi, I have a 2005 Chevy Colorado Z71 4 door with a 5 foot bed. I need to replace my current Truxedo tonneau cover but cannot find one that is the correct size. The part number on the railing is 1113645.

asked by: Joel B

0

Expert Reply:

I have a great solution for you. I went ahead and reached out to my contact at TruXedo, and she determined that the cover that you have in your pictures is the TruXedo Lo Pro Soft Roll-up Tonneau Cover - Black # TX539801. This cover is designed to fit your 2005 Chevy Colorado's 5-ft. bed. With that being said, my contact did say that the velrco on the hook as well as the cover looks worn as well as the rear header bar. She recommends completely replacing the cover due to the cost of all of the needed individual parts would be more than replacing the cover entirely. If you want to go the route of replacing the cover, the part you need is # TX539801-CVR.

expert reply by: Bob C

0

TruXedo Lo Pro Soft Roll-up Tonneau Cover - Black # TX539801
(click to enlarge)

Answer 1

The correct replacement cover for the TruXedo Lo Pro QT Soft Roll-up Tonneau Cover part #TX539801 on your 2006 Chevrolet Colorado is the Replacement Cover for TruXedo Lo Pro QT Soft, Roll-up Tonneau Cover part #TX539801-CVR.

view full answer...

Answer 2

From what I can see I believe you either have the TruXedo Pro X15 #TX1446601, which has a matte black finish, or the TruXedo Lo Pro QT #TX546601, which as a gloss black finish. If your cover has a matte black finish then that means you have the Pro…

view full answer...

Answer 3

TruXedo offers several different series of tonneau covers so you'll want to match yours to the ones shown on the linked page. The page displays all six TruXedo tonneau covers that fit your 2005 Dodge Ram 3500 short bed. The covers include the…

view full answer...

Answer 4

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

view full answer...

Answer 5

I recommend a 12 volt car battery rather than a breakaway battery because you may end up needing the larger battery down the road. What you will do is attach a battery box (see link for options) to the trailer frame. From the trailer side 7-Way…

view full answer...

Answer 6

You are correct in your description of how to wire in a new auxiliary battery in your enclosed trailer. You will take the 7-Way's 12V power feed and route this to the positive terminal on the auxiliary battery, and you will ground the second…

view full answer...

Answer 7

The best way to power the interior lights in your trailer is with its own independent battery. You will not want to use the breakaway battery. The breakaway battery is only designed to operate the breakaway and will drain extremely quickly,…

view full answer...

Answer 8

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 9

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Your slide-in truck camper does not have electric brakes so the blue brake circuit wire from its 7-way connector is not used. All other lighting functions as well as 12V auxiliary power will be maintained on the other circuits. Please refer to the…

view full answer...

What Replacement Tonneau Cover Do I Need for My TruXedo Lo Pro # TX539801?

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching