Are Just Taillights Available of Peterson Trailer Taillight Kit # V944

Question

Question:

Hi, Can I purchase just the lights without the whole kit? Thank you

asked by: Jim L

0

Expert Reply:

Yes just the light assemblies are available for the Trailer Taillight kit part # V944 that you referenced. For that you'd want the part # M844L for the left hand side and part # M844 for the right hand side.

expert reply by: Jameson C

0

Answer 1

The Standard Trailer Light Kit with 25' Wire Harness part #TL29BK as I am sure you noticed grounds via the mounting hardware therefore there is not a singular ground wire. In order to attach this light to a wooden surface you will need to run…

view full answer...

Answer 2

We do have a couple of really good options for you to replace your Peterson ##PM444L and #PM444, but you do have a keen eye because the Tail Light Kit #TLL16RK will not work with the 2-1/4" spacing you have. One of the lights would…

view full answer...

Answer 3

Both the pigtail and the trailer harness included with the Peterson #V944 LED Taillight Kit are 18 gauge, which is typical for trailer lamps and wiring harnesses. 18 gauge wire is actually perfectly sufficient for the reduced power draw of LED…

view full answer...

Answer 4

There is no need for any type of surge protection when making the switch to LED lights from incandescent. LED trailer lights, such as the Peterson #V944, are commonly being used to replace the less efficient incandescent lights.

view full answer...

Answer 5

The Peterson LED Tail Light Kit for Trailers Over 80" Wide - 25' Harness - Driver and Passenger #V944 you were looking at will work on your trailer as an upgrade to the incandescent lights given that your current lights are the same…

view full answer...

Answer 6

Yes, the 12 volt accessory circuit of your trailer wiring would be able to keep a 10 amp breakaway kit battery topped off like the part #3802311. Usually the 12 volt accessory circuit of a 7-way is protected with either a 30 amp or 40 amp fuse.

view full answer...

Answer 7

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

view full answer...

Answer 8

The marker lights would tie into the running light circuit, which is carried by the brown wire on the trailer wiring harness. I've linked you to a trailer wiring diagram, and also to our trailer wiring FAQ article.

view full answer...

Answer 9

With having 22'6" from your tail light location to the tongue on your trailer I recommend going with at least a 30' wiring harness. The additional length is needed so you will be able to route your wiring on the frame to the lights and…

view full answer...

Answer 10

A trailer that is over 80 inches wide is required by DOT regulations to have rear clearance lights. An over 80 inch taillight kit, like part #TL16RK, will have the side clearance light built into it. An under 80 inch taillight does not have the…

view full answer...

Answer 11

Typically the running light circuit will be noticeably dimmer than the brake/turn signal circuit, so what you described could be normal depending on how dim the lights are. Without seeing how dim the lights are it's hard to say for certain. If…

view full answer...

Answer 12

There is a couple of way to determine which wheel bearings and grease seals you will be needed for a trailer axle. First, checking the numbers on the wheel bearings and seal will allow you to select the correct parts for your axle. However, in some…

view full answer...