Slide-Out Awning For 80 Inch Flange to Flange Measurement

Question

Question:

I have an 80, flange to flange, slide out. What size awning? Thanks.

asked by: Blaisdell A

0

Expert Reply:

Thanks so much for that info, and we do have the exact slide-out awning you need for an 80 inch flange-to-flange measurement, which is the following part:

- Solera RV Slide-Out Awning # LCV000165062

This slide topper comes with everything you need for installation and will do a superb job of keeping your slide-out clean and free from any type of debris.

expert reply by: Kyle S

0

Answer 1

Thanks for that info and we do have the correct slide-out awning for your flange to flange measurement of 7 feet (or 84 inches). The part you need is the Solera RV Slide-Out Awning #LCV000165062. I have added links to a couple video reviews for you…

view full answer...

Answer 2

Basically the only thing that you gain with the hydraulic Level Up system is that hydraulic tends to be more powerful and it may be a little faster. Aside from that I recommend using the 6-Point Set Lippert Ground Control 3.0 Electric 5th Wheel RV…

view full answer...

Answer 3

In order to find the right fit, you will need one with a fabric size that extends a minimum of 2-1/2" beyond the width of your slide box and has 6" of clearance beyond the outside edges of the slide box. For example, the Solera…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Medic, so the Kenda ST235/75R15 Radial Off-Road Trailer Tire #KE68JR was designed for off-road traction but it is going to do really well in the wet and snowy conditions. Based on what you are looking for these are going to work well.

view full answer...

Answer 6

Sorry Jennifer, I am a bit confused as you were looking at the Replacement U-Clamp Bracket #RM-B141 which mounts with bolts and not U-bolts. This part works with the Split Bushing #RM-205217-10 for the discontinued Roadmaster Front Anti-Sway Bar…

view full answer...

Answer 7

Brien, it sounds like you did your research so kudos to you, but the awning you're looking at is not going to work with the wind sensor. You'd need to use the Solera Smart Arm 12V Power RV Awning #LC517517 instead. You're also going to…

view full answer...

Answer 8

Hi Joe, The Blue Ox Base Plate Kit #BX1139 is a confirmed fit for your 2024 Jeep Wrangler Rubicon X per Blue Ox. I don't currently have an installation video on a model with a steel bumper but I did measure from the mounting holes down to the…

view full answer...

Answer 9

Hey David, we've used the LaSalle Bristol RV Roof Vent install kit part #344270KITW to install several MaxxFan RV roof vents and it's worked well so it would also work well for you. This comes with everything needed so it would be a great…

view full answer...