Does NOCO AC Port Plug with Extension Cord # 329-GCP1 Have 14 Gauge Wire

Question

Question:

Does this have 14 gauge wire. Some Noco plugs specify 16 gauge which would be unacceptable as it is for a small camper van. Thanks

asked by: Doug O

0

Expert Reply:

Yes the NOCO AC Port Plug with Extension Cord # 329-GCP1 does use 14 gauge wire and is also rated for 15 amps.

expert reply by: Jameson C

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 3

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 4

Yes, there is a hitch that fits your 2023 Mercedes GLE 350. That hitch is the Stealth Hitches Hidden Rack Receiver #SH99MR. This hitch has a removable receiver for a completely hidden design when not in use. This version of the hitch has a max tongue…

view full answer...

Answer 5

For your 2020 Mercedes Benz GLE 350 SUV we have the Stealth hitch part #SH24GR which is a confirmed fit and actually comes with trailer wiring as well.

view full answer...

Answer 6

We have the bearing part #387A which is over 2 inches in inner diameter and is seen on 10,000 lb axles but I'd have to know exactly what your spindle dimensions are to know for sure what you'd need. If you can use a digital caliper like the…

view full answer...

Answer 7

Instead of using the Hydraulic Brake Kit #AKFBBRK-35-D which requires using 14"-16" wheels you should use the Dexter Galphorite Free-Backing Hydraulic Trailer Brake Assembly Right #T4423400 and Left #T4423500. These will fit with your…

view full answer...

Answer 8

The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel trailer…

view full answer...

Answer 9

Yes the Replacement Brass Connector #T4750300 for Titan Disc Brake Actuators will fit a Tie Down 660e disc brake actuator.

view full answer...

Answer 10

Thanks so much for the photos, and there isn't a replacement for just the front coupler portion of the long-discontinued coupler you have. So in order to switch out from a 2" to a 2-5/16" coupler attachment, you will need to replace the…

view full answer...