bing tracking image
Q & A Icon

Installation of Brake Buddy Supplemental Braking System on 2014 Honda CR-V  

Question:

Trying to figure out where to drill a hole in firewall of 2014 Honda CR V for the power harness to battery . Is there a measurement from a fixed point inside on firewall to drill a hole for the harness to go through . There are brake lines and brake booster on the engine side of firewall . Thanks

0

Expert Reply:

For installation of your Brake Buddy, # HM39524, you can route the wires through a grommet that is already being used for the factory wiring. I suggest you look underneath the brake fluid reservoir to the driver's side to locate a good option; push your wiring through here then use a pull from inside the cab of the vehicle. I have attached a couple of installation videos that will hopefully assist you.

expert reply by:
0
Michael R

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>