Replacement Converter Panel for Parallax 7345 to Allow it to be Used with Lithium Battery

Question

Question:

I need to upgrade a Parallax 7345 power supply so it can charge lithium batteries. Which converter to I buy? Or do I have to replace the entire unit?panel? The unit is a 2010 install I believe Thanks

asked by: Ricardo G

1

Helpful Expert Reply:

You'd need a new panel like the Progressive Dynamics Mighty Mini part # PD4045KA which is the most similar to your Parallax 7345 except is Lithium battery compatible.

There isn't a center section replacement available for what you have that would allow it to work with lithium batteries.

expert reply by: Jameson C

1

Answer 1

The Progressive Dynamics Mighty Mini AC/DC Panel #PD4045KA does not have an integrated transfer switch. Since you can't have two AC power sources connected at same time (generator and shore power) you do need to use a transfer switch like…

view full answer...

Answer 2

The heat side of most all units are able to be controlled by an external input as they operate by simply receiving a signal of when to turn on/off. I suggest you consider the Dometic Mechanical Thermostat - Furnace Control Only, #DMC54FR. Please…

view full answer...

Answer 3

We have the Progressive Dynamics Converter/Smart Charger at 35 Amp, #PD4135K. This is a replacement for WFCO WF-8735 that works with lithium-ion, flooded lead acid, AGM, and gel batteries. Please note the attached product review video and follow…

view full answer...

Answer 4

We have a great option in a replacement 45 amp power converter for your ELX-45. I suggest the Progressive Dynamics, #PD4045KA. This is a 2-in-1 AC/DC distribution panel and smart charger that works with lithium-ion, flooded lead acid, AGM, and gel…

view full answer...

Answer 5

Hey Jerry, so we have the Progressive Dynamics 4000 Series Mini RV Converter w/ Charge Wizard #PD4045KA that is rated for 45 amps and has a total of 12 DC fuses. 2 of them are 30 amp and 10 are 20 amp.

view full answer...

Answer 6

I have a solution for you, but you will need to determine the Workhorse chassis model that your coach is built on first; you can typically find this information on the spec sticker of your 2003 Fleetwood Bounder. If you've got a Workhorse W…

view full answer...

Answer 7

If you have a trailer wheel that has a 6 lug setup you are going to have a bolt pattern of 6 on 5-1/2 inches. This is the standard 6 lug wheel bolt pattern that trailer rims have. If you are unsure you can check out the help article I attached that…

view full answer...

Answer 8

Yes, both the Optronics lights #MC65RB and MCL75RB use the same mounting base, so the #MCL75RB lights will snap into your old bases. You will then need to wire in the lights, with a power and ground connection. Part #MCL75RB is a sealed LED light…

view full answer...

Answer 9

There are five mounting brackets available that fit the Optronics Trailer Clearance Side Marker Light #MC65AB. These three are all black plastic. They are Optronics #A65PBPG, #A65PB and #A65B. The first two come with a single wire, the…

view full answer...

Answer 10

When installing the Optronics Sealed, Thin Line LED Light, #MCL75RB, you will use the #A65PB Bracket for Single Wire Thin Line Light. The bracket has a black wire that the power wire on your trailer will connect. The light will ground to the trailer…

view full answer...

Answer 11

I have a solution for you but there isn't just a replacement converter section for the Elixir ELX-45. You're going to need to replace the entire panel with the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger item…

view full answer...

Replacement Converter Panel for Parallax 7345 to Allow it to be Used with Lithium Battery

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching